User Manual



MLT18/MLR18UserManual
SETUP
1. Removethetransmitterholderontherearsideoftransmitter

2. Findthelocationwouldliketoinstall,itoccupiesspacearound10W*14H*10Deepcm,fixthe
holderbytwoscrewsincludedinpackage
3. Slidebatterycoveroffonrearside,insert3“AAA”batteriesfollowing(+)and(‐)indicatedon
insideofbatterycompartment,closecap
DO NOT
mix old and new batteries, DO NOT mix alkalin, standard(carbon‐zinc) or
rechargeable(Ni‐Cad,Ni‐mh,etc)batteries.
DONOTdisposeofbatteriesinfire,batteriesmayexplodeorleak
4. Slide the switch to choose the delayed time ,after motion/dusk is detected, 4 options :1
minute;5minutes,15minutes,30minutes

5. Slide the switch to choose the channel labeled on the package ,or receiver can not turn
on/offcorrectly
6. Twisttheswitchonthefrontsidetochoosethemode.Thereare4options:
A. Random mode.Will turn on the receiver for a period of 10 minutes
to 2 hours, then
keepofffora periodof10minutesto2hours
B.CDSmode.Willturnonthereceiverwhenduskandturnoffwhendawn
C.Automode.willturnonthereceiverwhenmotionisdetectedatnight.bluelightwillturn
ontelling
you:“Iseeyoumotion”
D. Motion mode. will turn on the receiver once motion is detected, blue light will turn on
tellingyou:“Iseeyoumotion”.
7. Mount transmitter back to holder, adjust the position and make the window towards the
mostareayouwouldlike
tobedetected.
8. Plug in receiver ,and connect receiver with load ,such as light etc, the distance between
receiverandtransmitterisupto100feetintheopenarea.
Ratings:
433.92MHz
120V,60Hz,
12A,1440Wresistive
3A,360Wtungsten



