Installation Instructions
M965837 (7/18)
RETROFIT SIDE-MOUNT
OPERATOR FOR PISTON FLUSH
VALVES
FOR URINAL & TOILET FLUSH VALVES
INSTALLATION
• Remove handle assembly from installed ush valve.
Note: Keeping a rag to prevent water seepage.
• Slide ANGLE LOCKING RING (2) onto FLUSH VALVE (1).
Note: Square end of the ANGLE LOCKING RING (2) should
be facing the wall.
• Install ADAPTER (3) onto FLUSH VALVE (1) using the
wrench provided.
• Install FLAT SEAL (4) into FLUSHING UNIT (5).
Install FLUSHING UNIT (5) onto ADATER (3) using the
wrench provided.
Note: There is a ±13 mm, (±1/2) tolerance for
the 121 mm (4-3/4) dimension.
ACTIVATION
• Remove BATTERY TRAY (1) by loosening SCREW (3).
• Load 4 “C” Alkaline BATTERIES (5) onto BATTERY
TRAY (1).
• Install battery tray into FLUSHING UNIT (2) and tighten
SET SCREW (3) using WRENCH (4) provided.
(Note: last three turns of the wrench will activate the
automatic ushing unit)
Note: Four (4) “C” Cell batteries are not factory installed
inside the Flush unit.
- -
+
-
+ +
1
5
2
3
4
Fig. 8
1
121 mm, 13 mm
(4-3/4")( 1/2")
+
–
+
–
5
4
2
3
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2018
Thank you for selecting American Standard...
the benchmark of fine quality for over 140 years.
To ensure that your installation proceeds smoothly-please
read these instructions carefully before you begin.
INSTALLATION
INSTRUCTIONS