Instructions / Assembly
1
Product names listed herein are trademarks of AS America Inc.
© AS America Inc. 2014
7302171-101
VORMAX
™
www.americanstandard-us.com/vormaxparts
2
Product names listed herein are trademarks of AS America Inc.
© AS America Inc. 2014
VORMAX
™
7302171-101
NUT &
GASKET
FIGURE 6
www.americanstandard-us.com/vormaxparts
FLAPPER ASSEMBLY
with TEETER BAR
PART NUMBER:
7381423-100.0070A
• Flapper assembly including adjustable
teeter bar with clevis & hair pin
TO REMOVE FLAPPER ASSEMBLY:
• Turn off water supply; flush toilet
(remove all water from the tank)
• Remove hair pin FIGURE 1
• Remove clevis pin; this frees the teeter bar
from the trip lever arm FIGURE 1
• Place fingers underneath hinge and pull up to
release all 4 hinges FIGURE 2
• Remove original flapper assembly from tank
TO RE-INSTALL:
• Place the black flapper to the black flush valve
body with the overflow tube and the red flapper
to the flush valve body with the red cap and
push all 4 hinges in place (red to red/black to black)
• Insert the trip lever arm in to the yoke FIGURE 1
• Push the clevis pin through the arm FIGURE 1
• Insert the hair pin FIGURE 1
FLAPPER ASSEMBLY
with TEETER BAR
PART NUMBER:
7381423-100.0070A
COMPLETE BY ADJUSTING THE SETTINGS:
• Depress trip lever handle all the way (A)
• Adjust screw on the teeter bar (B) so rear frame (C)
touches the frame stop (D)
• Return trip lever handle (A) to rest position.
• Make sure hook (E) is fully engaged under tab on valve body (F),
if not, slightly adjust screw to make sure hook is engaged.
• Turn water supply on; adjust water level to specified dimension
on back of tank and flush 5 times to prime
(E)
(F)
(A)
(C)
(D)
(B)
HOOK
CROCHET
HAIR
PIN
CLEVIS
PIN
YOKE
➞
➞
➞
FIGURE 1
➡
PUSH
UP
FIGURE 2