Installation Guide

- 1 -

Product names listed herein are trademarks of AS America, Inc.

RECOMMENDED TOOLS

M965993 (10/18)

Delancey

Dual Control Widespread

Lavatory Faucet

INSTALLATION

INSTRUCTIONS

7052807

7052827

7052814

Flat Head Screwdriver

Adjustable Wrench Tubing CutterSlip Jaw Pliers

Certied to comply with ANSI A112.18.1M

Thank you for selecting American Standard...

the benchmark of ne quality for over 140 years.

To ensure that your installation proceeds smoothly-please read

these instructions carefully before you begin.

INSTALL SPOUT

CAUTION

Turn off hot and cold water

supplies before begining.

INSTALL VALVE BODIES

Fig. A.

• Insert SHANK (1) and HOSE (2) through center hole, making sure

SEAL WASHER (3) is properly seated in spout base.

• From below, push RETAINING WASHER (4) onto SHANK (1). Secure faucet

with MOUNTING NUT (5).

• Align and center SPOUT. Tighten MOUNTING NUT (5).

Fig. A.

Fig. B.

SPOUT BASE

8 Blue Stripe (COLD)

8 Red Stripe

(HOT)

Fig. B.

• Remove LOCKNUT (6) from SIDE VALVE SHANKS (7).

• Insert Hot and Cold SIDE VALVE HOSES (8),

FLEXIBLE SUPPLIES (8a) into mounting holes.

• Thread LOCKNUT (6) onto each SIDE VALVE

SHANK (7) from underside of sink or

mounting surface.

• Align and center SIDE VALVES. Tighten

LOCKNUTS (6).

PAGE 1
INSTALLATION INSTRUCTIONS 7052807 7052827 7052814 Delancey® Dual Control Widespread Lavatory Faucet Thank you for selecting American Standard... the benchmark of fine quality for over 140 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.1M RECOMMENDED TOOLS Flat Head Screwdriver 1 INSTALL SPOUT CAUTION Fig. A.
PAGE 2
INSTALL DRAIN FROM BELOW FIXTURE 3 REAR OF SINK DRAIN OUTLET 2 1 3 1 2 • Thread TAIL PIECE NUT (1) clockwise onto DRAIN BODY (2). • Install DRAIN (1) by dropping it from the top of the sink. • From under side of SINK install GASKET (2) and MOUNTING NUT (3). Note: Plumber’s putty or caulk is recommended. 4 FLANGE GASKET AND POP-UP KNOB FOAM GASKET NOT VISIBLE 5 CHECK OPERATION OF POP-UP 1 DRAIN FLANGE • Operate DRAIN STOPPER (1) to verify that it opens and closes.
PAGE 3
7 SERVICE Change Direction of the Handle • Turn valves to OFF position. • Turn off water supplies. • Pull HANDLE (1) “UP” firmly to release from ESCUTCHEON (6). • Remove SCREW (3) and pull off PLASTIC INSERT (2). • Remove CARTRIDGE NUT (8). • Remove RETAINING O-RING (4). • Lift and turn STOP WASHER (5) 90˚. Replace RETAINING O-RING (4). • Re-install HANDLE ASSEMBLY. To Change Cartridge: • Remove HANDLE (1), ADAPTER (2), SCREW (3) and CARTRIDGE NUT (8) via steps above.