Installation Guide

- 1 -

Product names listed herein are trademarks of AS America, Inc.

Thank you for selecting American Standard...

the benchmark of ﬁne quality for over 140 years.

To ensure that your installation proceeds smoothly-please read

these instructions carefully before you begin.

RECOMMENDED TOOLS

INSTALL FAUCET

Delancey

Centerset Lavatory Faucet

INSTALLATION

INSTRUCTIONS

7052207

7052214

Certied to comply with ANSI A112.18.1M

CAUTION

Turn off hot and cold water

supplies before begining.

M965986 1.0 (5/19)

• Apply a bead of PUTTY along the edge of the

underside of the BODY. Insert FAUCET (1)

through mounting holes of Sink or mounting

surface. Fig. A.

• Assemble LOCKNUTS (2) onto SHANKS (3) from

under side of Sink. Hand tighten rmly. Fig. B.

Adjustable Wrench Screwdriver Channel Locks

Tubing Cutter

(HAND TIGHTEN)

Fig. B.

SINK OR

MOUNTING

SURFACE

PUTTY

Fig. A.

HOT LINE FOR HELP

For toll-free information and answers to your questions, call:

1 (800) 442-1902

Mon. - Fri. 8:00 a.m. to 8:00 p.m. EST

Saturday 10:00 a.m. to 4:00 p.m. EST

IN CANADA 1-800-387-0369

(TORONTO 1-905-306-1093)

Weekdays 8:00 a.m. to 7:00 p.m. EST

IN MEXICO 01-800-839-1200

PAGE 1
INSTALLATION INSTRUCTIONS 7052207 7052214 Delancey® Centerset Lavatory Faucet Thank you for selecting American Standard... the benchmark of fine quality for over 140 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.1M RECOMMENDED TOOLS Screwdriver 1 INSTALL FAUCET CAUTION Channel Locks Adjustable Wrench Tubing Cutter Turn off hot and cold water supplies before begining.
PAGE 2
INSTALL DRAIN FROM BELOW FIXTURE 3 REAR OF SINK DRAIN OUTLET 2 1 3 1 2 • Thread TAIL PIECE NUT (1) clockwise onto DRAIN BODY (2). • Install DRAIN (1) by dropping it from the top of the sink. • From under side of SINK install GASKET (2) and MOUNTING NUT (3). Note: Plumber’s putty or caulk is recommended. 4 FLANGE GASKET AND POP-UP KNOB FOAM GASKET NOT VISIBLE 5 CHECK OPERATION OF POP-UP DRAIN FLANGE 1 • Operate DRAIN STOPPER (1) to verify that it opens and closes.
PAGE 3
7 TEST INSTALLED FITTING • With HANDLES (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks. • Remove AERATOR (3). • Operate both HANDLES (1) to flush water lines thoroughly. 3 • Replace AERATOR (3). 1 1 CHECK DRAIN CONNECTIONS • Fill lavatory with water. Check that DRAIN STOPPER (4) makes a good seal and retains water in SINK. • Check all drain connections and “P” trap for leaks. Tighten if necessary.