Manualshelf

Installation Guide

ManualsBrandsAmerican Standard ManualsBathGreen Tea 18 in. Towel Bar in Stainless-Steel
123
Certified to comply with ANSI A112.18.1
1
MOUNTING BRACKET INSTALLATION
18" TOWEL BAR, 24" TOWEL BAR AND 24" GLASS SHELF
The 18" TOWEL BAR, 24" TOWEL BAR and GLASS SHELF work best if secured to a wall stud or cross brace within the wall, using 1-1/2"
long SCREWS (3) not supplioed.
If the 18" TOWEL BAR, 24" TOWEL BAR and GLASS SHELF are to be installed on a tile or plaster wall the ANCHORS and SCREWS
should be used.
GREEN TEA
Installation
Instructions
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--
please read instructions carefully before you begin.
INSTALL 18" TOWEL BAR, AND 24" TOWEL BAR
2
18" TOWEL BAR
24" TOWEL BAR
18" GLASS SHELF
24" GLASS SHELF
Regular Screwdriver
Level
Recommended Tools
Phillips Screwdriver
Drill
10'
Tape Measure
Secure MOUNTING PLATES (1) to wall with SCREWS (2).
Determine desired height and location (optional) for the accessory and mark a center line. Use the full size template supplied to mark
hole locations for the mounting brackets. For the 24" TOWEL BAR and GLASS SHELF use 24” template. For 18” TOWEL BAR use 18”
template. If MOUNTING BRACKET (1) is secured to a stud or cross brace drill small pilot holes for SCREWS (3).
For installations on drywall or tiled walls, use ANCHORS (4) and SCREWS (2) for securing MOUNTING BRACKETS (1) to wall. Use MOUNTING
BRACKET (1) as a template and mark the mounting holes. Drill three 1/8" diameter holes a minimum of 1-1/4" deep. Insert the three
ANCHORS (4) flush with face of the finished wall.
Place right ESCUTCHEON (5) onto MOUNTING BRACKET (1), and secure
with SET SCREW (6) using 2.5 mm HEX WRENCH (7) supplied.
Place LEFT ESCUTCHEON (5a) onto MOUNTING BRACKET (1a) and
secure with SET SCREW (6) using 2.5 mm HEX WRENCH (7) supplied.
5,
1a
1
6
6
5
5a
5a
4
FINISHED WALL
2
1
1-1/2"
4
1
2
DRILL 3 PILOT HOLES FOR
WOOD SCREWS (2) OR
1/8" DIA. HOLES FOR
ANCHORS (4)
CENTER
LINE
CENTER
LINE
LEVEL
3
24" (610mm)
18" (457mm)
or
6
7
CENTER LINE
(OPTIONAL TO
FINISHED FLOOR)
TEMPLATE
FINISHED WALL
ANCHORS
MOUNTING
BRACKET
MOUNTING
SCREWS
(SUPPLIED)
24" (610mm)
24" TOWEL BAR
GLASS SHELF
7010.2407010.024
DRILL 3 PILOT HOLES FOR
WOOD SCREWS (2) OR
1/8" DIA. HOLES FOR
ANCHORS (4)
CENTER
LINE
MOUNTING BRACKET
for GLASS SHELVE
MOUNTING BRACKET
for GLASS SHELVE
18" (457mm)
POSITION OF
MOUNTING BRACKET
FOR TOWEL BARS
M968631 Rev. 1.2
7010.180
7010.240
7010.018
7010.024
18" TOWEL BAR
7010.180
18" GLASS SHELF
7010.018

Summary of content (3 pages)