il Bl Installation COPELAND Instructions Spread Lavatory Faucet with 7005.801 Speed Connect™ Drain Congratulations on purchasing your American Standard faucet with Speed Connect drain, a feature found only on American Standard faucets. Speed Connect™ Drain* Certified to comply with ANSI A112.18.1 « Fewer parts, installs in less time M968834 + Never needs adjustment « Guaranteed to seal properly the first time, every time.
= Remove CLEAR PLASTIC COVER (1). ® Remove CARDBOARD SPACER (2) from under DRAIN POP-UP [3). m Tighten TAILPIECE (4] on DRAIN BODY before installing DRAIN BODY. Fig. B. Fig. B. ® Thread FLANGE (1) counter-clockwise and remove FLANGE (1) and FOAM GASKET (2) from drain body. Fig. A. B Thread LOCKOUT (3] clock-wise to bottom of drain body. Push GASKET [4) down against LOCKOUT (3). Fig. B. INSTALL DRAIN FROM BELOW FIXTURE ® From under side of SINK install DRAIN BODY (1) up through drain outlet.
ATTACH CABLE CONNECTOR ® Thread GABLE CONNECTOR [1) clockwise note DRAIN BODY CONNECTION (2) and hand tighten. Fig. A. Your new POP-UP DRAIN installation is now complete. Flg. B. Note: Tailpiece on pop-up drain is 0.D. Fig. B. E CHECK OPERATION OF POP-UP ¥ Operates LIFT KNOB [1] to verify that STOPPER (2) opens and closes. Note: If STOPPER (2) does not open and close properly then refer to the “troubleshooting section” of theses instructions.
m INSTALL HANDLES m Push ADAPTER (1) on VALVE STEM (2), so that the hole of the 8 . ADAPTER (1) without a spline is facing up. Fig. A. Tighten STEM SCREW [3) to secure ADAPTER [1). s—¢ a B Align HANDLE BASE (4) and push onto DECK ADAPTER (5] until flush against mounting surface. B Find correct position of LEVER HANDLE {8) by adjusting male test on ADAPTER [1) to female test in HANDLE (6). i L B Tighten SET SCREW (7) with HEX WRENCH (8) SUPPLIED.
Speed Connect™ Drain Troubleshooting Guide If sink does not hold water even though BF?F" is in the “down” position: Follow GABLE ADJUSTMENT P URE.
STOPPER INSTALLATION PROCEDURE The Stopper can be installed two ways, “Locked” Mode (Stopper cannot be removed) or “Unlock™ Mode (Stopper is removable). Locked Soda: ® | pok at the Plastic Loop at the bottom of the Smugger and notice that the Loop is on one side of the Stopper. Fig. G. m To install the stopper in “Locked” mode, insert the Stopper into the Drain so that the Plastic Loop is facing toward the rear of the Sink and the American Standard logo is facing front.