Installation Guide

SPREAD LAVATORY
FAUCETS
Installation
Instructions
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--
please read these instructions carefully before you begin.
Certified to comply with ANSI A112.18.1M
M965046 Rev.1.3
Turn VALVES (1) to off position.
Insert ADAPTOR (7) with larger diameter over the VALVE STEM (4).
Align LEVER (2) or WRIST BLADE HANDLE (3) and install onto VALVE STEM (4).
Insert BLUE INDEX (5) into cold valve (right side) and red INDEX (6) into hot valve (left side).
Insert HANDLE SCREW (6) into HANDLES and tighten with screwdriver.
INSTALL HANDLES
2
Turn off water at
main supply.
CAUTION
Adjustable Wrench Screwdriver Channel Locks
Recommended tools
Tubing Cutter
4
1
3
7
2
5
6
6530.173
6540.180
6545.Series
8
3
1
2
1
Push TUBING (7) ends into VALVES (6, 6a) side outlets. Insert VALVES (6, 6a)
into mounting holes from underside of ledge.
Install LOCKNUTS (1), BRASS WASHERS (2) and RUBBER WASHERS (3) onto
valve shanks.
Place RUBBER RING (8) into ESCUTCHEON (9) and thread onto VALVES (6, 6a)
until snug against internal stop.
Tighten LOCKNUT (1) to secure VALVES (6, 6a) into position.
Firmly tighten COUPLING NUTS (5).
Install FERRULE (4) into COUPLING NUT (5). Thread onto VALVE (6, 6a) and
loosely tighten COUPLING NUTS (5).
Connect HOT water supply to inlet of left VALVE and COLD water supply to inlet of
right VALVE using appropriate connector.
INSTALL VALVE ASSEMBLIES
HOT
COLD
4
6
6a
5
5
4
7
9
8
9
MOUNTING
LEDGE
3
5/16" MIN.
MOUNTING SURFACE
9
3
6
8
1
2