Installation & Assembly

SPREAD LAVATORY
FAUCETS
Installation
Instructions
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--
please read these instructions carefully before you begin.
Certified to comply with ANSI A112.18.1M
1
Insert SPOUT SHANK (1) through center hole of mounting surface, making sure
RUBBER GASKET (2) is properly positioned in SPOUT BASE (3).
SPOUT OR BASE ASSEMBLY
1a
Assemble RUBBER WASHER (4), BRASS WASHER (5), and LOCKNUT (6) onto threads of
SPOUT SHANK (1) from underside of mounting surface.
Align SPOUT (7) and tighten LOCKNUT (6). Be sure slot in BRASS WASHER (5) is
positioned to the rear as shown.
Turn off water at
main supply.
CAUTION
Adjustable WrenchChannel Locks
Recommended tools
Tubing Cutter
TO CHANGE SPOUT TO A SWIVEL SPOUT:
Unscrew SPOUT NUT (8) and remove SPOUT (7).
Take SPOUT CLIP (9) off SPOUT (7) and remove RUBBER RING (10).
Replace RUBBER RING (10) with seperate PLASTIC RING (11) packed with faucet.
Put SPOUT CLIP (9) on SPOUT (7).
Reassemble SPOUT (7) to SPOUT BASE (3).
1
2
3
4
7
5
6
7
8
10
9
11
M965453 REV. 1.2 (7/15)
Phillips Screwdriver
DRAIN ASSEMBLY (6542.177, 6542.178)
2
1
2
3
4
6
Apply a bead of PUTTY around underside of DRAIN PLUG (1) flange.
Insert DRAIN PLUG (1) into lavatory drain hole.
Hold DRAIN PLUG (1) to prevent turning and assemble GASKET (2),
WASHER (3) and LOCKNUT (4) from underneath sink. Tighten with
adjustable wrench or channel locks.
Make sure SEAL (5) is inserted
into bottom of DRAIN PLUG (1).
Insert threaded end of TAILPIECE
(6) into lower end of DRAIN
PLUG (1) and tighten.
Connect other end to P-Trap.
PUTTY
LAVATORY
DRAIN
5
6540.171
6540.177
6540.178
6540.179
6540.188
6542.177
6542.178