Installation Instructions

ManualsBrandsAmerican Standard ManualsBathStallbrook Washout Urinal in White

BEFORE YOU BEGIN:

SAVE FOR FUTURE USE

7302142-100

CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

Product names listed herein are trademarks of AS America Inc.

NOTES:

• Pictures may not exactly define contour of china and components.

• Observe all local plumbing and building codes.

• Refer to local codes and manufacturer’s instructions for flush valve requirements.

• Carefully inspect the new urinal for damage.

• Fixture dimensions are nominal and conform to tolerances by ASME Standard A112.19.2.

• Site preparation may require additional tools and hardware.

Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To

ensure this product is installed properly, please read these instructions carefully before you begin.

(Certain installations may require professional help.) Also be sure your installation conforms to

local codes.

STALLBROOK URINAL

6400 SERIES

INSTALLATION INSTRUCTIONS

RECOMMENDED TOOLS AND MATERIALS

Safety Glasses Adjustable Wrench Pencil Tape Measure

Thread Sealant Blade Screwdriver Levels

CAUTION: RISK OF PERSONAL INJURY OR PRODUCT DAMAGE. HANDLE WITH CARE.

VITREOUS CHINA CAN BREAK OR CHIP IF THE PRODUCT IS HANDLED CARELESSLY.

CAUTION: RISK OF PRODUCT DAMAGE. DO NOT OVERTIGHTEN THE BOLTS.

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS STALLBROOK URINAL 6400 SERIES Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes. CAUTION: RISK OF PERSONAL INJURY OR PRODUCT DAMAGE. HANDLE WITH CARE. VITREOUS CHINA CAN BREAK OR CHIP IF THE PRODUCT IS HANDLED CARELESSLY.
PAGE 2
Roughing-in IMPORTANT: Roughing-in dimensions may vary 1/2" (13 mm) and are subject to change or cancellation without prior notice. No responsibility is assumed for use of superseded or voided spec sheets/installation instructions. 121mm (4-3/4") 3/4" S.P.S. SUPPLY TO FLUSH VALVE 3/4" SPUD FINISHED WALL 133mm (5-1/4") 292mm (11-1/2") 76mm (3") C/L 972mm (38-1/4") 381mm (15") 457mm (18") 203mm (8") FINISHED FLOOR 102mm (4") 89mm (3-1/2") DIA. OUTLET C/L OF OUTLET 208mm (8-3/16") 1 PREPARATION 1a.
PAGE 3
2 INSTALL THE STRAINER (provided by others) CAUTION: Urinals should not be cast in, clamped, or rigidly fastened to floors or walls. Wainscoting should never be set directly on top of urinals. Do not use wood blocks under stall. Soil lines and traps should be anchored solidly to prevent piping strain. Do not install urinal until one week after rough floors are cast. 4-1/2" (114 mm) 4-3/8" (111 mm) 3-1/4" (83 mm) 1/2" (13 mm) MIN. 1-3/8" (35 mm) MAX.
PAGE 4
3 COMPLETE THE INSTALLATION a. Install the flush valve according to the manufacturer’s instructions. b. Connect the water supply. c. Turn on the water supply. d. Flush and check the entire installation for leaks. CARE & CLEANING Wash with mild soapy water and rinse thoroughly. Dry with a soft cloth. Avoid detergents, disinfectants or cleaning products in aerosol cans as they may damage fittings. In the United States: American Standard Brands P.O.