Installation Sheet

6. Connect DISHWASHER OUTLET
HOSE (5/8" O.D.) to AIR GAP
inlet (smaller diameter leg) and
to DISHWASHER outlet using
HOSE CLAMPS.
.
7. Connect drain hose (7/8" I.D.)
to AIR GAP outlet (larger dimension
leg) and to "Y" fitting or Disposer
using hose clamps.
DISHWASHER
AIR
GAP
NUT
SEAL
WASHER
CAP
(F/L)
RIBBED
NUT
AIR GAP
INSTALLATION
INSTRUCTIONS
BASKET STRAINER
INSTALLATION INSTRUCTIONS
DISHWASHER
OUTLET HOSE
(5/8" ID)
GARBAGE
DISPOSAL
2. Insert AIR GAP through sink
deck hole, leaving approximately
1/2"of the body threads showing
above sink deck. (Back the NUT
down if necessary).
3. Thread RIBBED NUT fully onto
BODY.
1. Remove CAP and RIBBED NUT.
4. Tighten NUT firmly.
5. Snap CAP onto RIB NUT,
with the slotted vents
facing the wall.
Air gap to be installed that the flood level mark
(F/L) shall be at or above the flood level of the
sink or other receptacle which may be connected
to the sanitary drain into which the air gap
discharges.
IMPORTANT
1. Remove all components from Strainer Body (1).
2. Apply a generous amount of plumber's putty to
underside of Strainer Flange. Insert Strainer
Body (1) through drain hole in sink.
3. Hold Strainer Body (1) firmly in place while installing
under the sink the Rubber Washer (2), Friction
Washer (3).
4. Hold Strainer Body (1) from rotating and thread Lock-
Nut (4) onto Strainer Body (1) using a basin wrench.
Tighten securely.
5. Insert Flanged Tailpiece Washer (5) into Tailpiece (6)
(not Supplied) and install Slip nut (7) with boss facing
upward, tighten firmly with wrench.
6. Remove excess putty from around Strainer Flange.
7. Drop in Strainer Basket (8).
1
8
2
3
4
5
6
7
Putty
(Not
Supplied)
DRAIN
HOSE
(7/8" ID)
HOSE
CLAMP
HOSE
CLAMP
TRAP
"Y"
FITTING
OR