Installation Guide

SINGLE CONTROL PULL-OUT

KITCHEN FAUCET

Installation

Instructions

M968517

Certiﬁed to comply with ANSI A112.18.1M

CAUTION

INSTALL FITTING

Turn off hot and cold water

supplies before beginning.

Plumbers' Putty or Caulking

Adjustable Wrench

Phillips Screwdriver

Channel Locks

Recommended Tools

Make certain the O-RING SEAL (1) is properly seated

in recess of faucet body.

Insert supply HOSES (2), SHANK (3) and SPRAY

HOSE (4) through center hole of sink or mounting

surface.

Assemble RUBBER WASHER (5), PLASTIC WASHER (6),

RUBBER & METAL “C” WASHERS (7) and long LOCKNUT (8)

onto SHANK (3) from underside of sink. Hand tighten

LOCKNUT (8) and check that faucet is centered.

Tighten LOCKNUT (8) with WRENCH (12) supplied. Insert

screwdriver into hole in WRENCH (12) and tighten.

Feed HOSE END (9) through HOSE GUIDE (10). Slide other

side of HOSE GUIDE (10) onto SHANK (3) and secure with

LOCK NUT (11). Do not over tighten!

Tubing Cutter

SCREWDRIVER

RECESS

Thank you for selecting American-Standard...the benchmark

of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly--please

read these instructions carefully before you begin.

4332.310.XXX

4332.410.XXX

PEKOE

SINGLE CONTROL PULL-OUT

BAR FAUCET

PAGE 1
Installation Instructions PEKOE 4332.310.XXX 4332.410.XXX SINGLE CONTROL PULL-OUT KITCHEN FAUCET SINGLE CONTROL PULL-OUT BAR FAUCET Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.
PAGE 2
MAKE WATER SUPPLY CONNECTIONS Turn off hot and cold water supplies before beginning. Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply (Marked with a Red Stripe) to Hot and right supply (Marked with Blue Stripe) to Cold wall supply. Use adjustable wrench to tighten connections. Do not over tighten. BLUE STRIPE RED STRIPE Faucet supplies are 27-1/2" long from faucet base.
PAGE 3
4 TEST INSTALLED FAUCET 3 Move HANDLE (1) into "off" position. 5 Unthread SPRAY HOSE (3) from SPRAY (2). 1 2 Turn on water supplies and check connections for leaks. Hold HOSE END (3) in sink and operate HANDLE (1) on and off, hot and cold to flush water lines thoroughly. Replace SPRAY (2). Pull SPRAY (2) out and check hose and supply connections for leaks. Check that SPRAY HOSE (3) and WEIGHT (4) slide up and down freely and do not interfear with supplies or waste outlet plumbing.