Installation Guide

1 REMOVE OLD TOILET
a. Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.
b. Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply!
c. Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.
d. Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE: Mounting surface must be clean and level before new toilet is installed!
INSTALL CLOSET BOLTS
Install closet bolts in flange channel, turn 90
°
, and slide
into place 6" (152 mm) apart and parallel to wall.
3
2
CLOSET FLANGE
CLOSET BOLTS
730913-100 Rev. D
A
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND
POSSIBLE INJURY HANDLE WITH CARE!
Product names listed herein are trademarks of American Standard Inc.
© American Standard Inc. 2006
!
NOTE: Pictures may not exactly define contour of china and components.
SAVE FOR FUTURE USE
INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
Williamsburg Champion® 2-piece Toilets
Thank you for selecting American Standard - the benchmark of fine quality for
over 100 years. To ensure this product is installed properly, please read these
instructions carefully before you begin. (Certain installations may require
professional help.) Also be sure your installation conforms to local codes.
RECOMMENDED TOOLS AND MATERIALS
Putty Knife Regular Screwdriver Adjustable Wrench Sealant
Hacksaw Wax Ring/Gasket Flexible Supply Tube 1/2" Deep Well Nut Driver or
Closet Bolts Tape Measure Carpenters Level Deep Well Socket Wrench
Recommended fitting type for back-to-back installations.
Depending upon your plumbing and venting conditions, the flow from
the Champion in a back-to-back installation may create a vacuum on
the system and draw water from the opposing bowl. The National
Standards Plumbing Code prohibits the use of a cross fitting for
drainage as throw over is possible. The code does approve a
directional "Y" style fitting with proper venting to direct the water
downward and away from the other toilet.
NOTE: BACK-TO-BACK INSTALLATION
MODEL A B C D
DIMENSIONS
Right Height
Elongated
2-pc Toilet
Normal
Height
Round Front
2-pc Toilet
18-1/2"
470mm
16-1/2"
419mm
30-3/8"
772mm
34-3/8"
873mm
16-1/2"
419mm
15-1/4"
387mm
28-3/8"
721mm
33-1/2"
851mm
ROUGHING-IN DIMENSIONS: Right Height™ Elongated Two Piece Toilet
Normal Height Round Front Two Piece Toilet
FINISHED WALL
19mm ± 6mm
(1 ± 1/4)
B
FINISHED
FLOOR
305mm
(12)
C
C/L OF OUTLET
83mm
(3-1/4)
216mm
(8-1/2)
A
362mm
(14-1/4)
264mm
(10-3/8)
16mm
(5/8)
D
479mm
(18-7/8)
SUPPLY
AS
REQ'D
254mm
(10)
152mm
(6)
254mm
(10)
356mm
(14)