Installation Guide

ManualsBrandsAmerican Standard ManualsPlumbingStudio S 68" Free Standing Acrylic Soaking Tub with Center Drain and Overflow

All product names listed herein are trademarks of AS America, Inc. unless otherwise noted.

Local building codes vary by location. Observe all local plumbing and building codes.

Your new bath is shipped to you after careful inspection.

To ensure maximum performance and pleasure from this product, please follow the instructions and cautions.

• Level

• Square

• Tape Measure

• Pipe Wrench

• Slip Joint Pliers

• Standard Woodworking Tools

• Personal Safety Equipment

• Caulking Gun

• Silicone Caulking

• Tub & Tile Caulk

BEFORE YOU BEGIN....

TOOLS:

TOOLS & MATERIALS REQUIRED

MATERIALS:

ROUGH-IN INFORMATION:

FREESTANDING TUB

Model 2549

SAVE FOR FUTURE USE

INSTALLATION INSTRUCTIONS

Thank you for selecting American Standard...the benchmark of fine quality for over 100 years. To ensure that your

installation proceeds smoothly--please read these instructions carefully before you begin.

755021-100 Rev. 4 8/19

FREESTANDING TUB

HIGH GLOSS ACRYLIC SURFACE

NOTE: Take extra care in handling surfaces of the bath. Use only non-abrasive cloths to avoid scratching.

Note: An access panel must be

provided to facilitate the connection

of the drain to the drain/waste outlet.

Access must be made through the

floor below the tub.

Using the OS&B

Island Tub Drain or

Summary of content (5 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FREESTANDING TUB HIGH GLOSS ACRYLIC SURFACE Models: 2549, 2765, 2766, 2767 Thank you for selecting American Standard...the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin. BEFORE YOU BEGIN.... Local building codes vary by location. Observe all local plumbing and building codes. Your new bath is shipped to you after careful inspection.
PAGE 2
68-3/4" (1745 mm) ROUGH-IN INFORMATION: FREESTANDING TUB Model 2765 31-1/4" (795 mm) ø2-1/8" (ø55 mm) 5-1/8" (130 mm) Note: An access panel must be provided to facilitate the connection of the drain to the drain/waste outlet. 16-7/8" (430 mm) 23-5/8" (600 mm) Access must be made through the floor below the tub. Using the OS&B® Island Tub Drain or similar product may eliminate the need for an access panel. Refer to the manufacturer's installation instructions for details.
PAGE 3
69-5/8" (1768 mm) ROUGH-IN INFORMATION: FREESTANDING TUB Model 2767 3-1/8" (80 mm) 11" (280 mm) 4-3/8" (110 mm) ø2-1/8" (ø55 mm) 31-3/4" (805 mm) 5-1/8" (130 mm) 17-3/8" (440 mm) Note: An access panel must be provided to facilitate the connection of the drain to the drain/waste outlet. 1 23-5/8" (600 mm) 63-3/16" (1604 mm) Access must be made through the floor below the tub. Using the OS&B® Island Tub Drain or similar product may eliminate the need for an access panel.
PAGE 4
3 Remove the tub. FLOOR CUTOUT Using the traced outline for reference, confirm that the drain/waste outlet in the floor will align with the tub drain outlet. (Tub drain outlet will be located in the center of the traced outline. See Fig. 3) Note: The drain/waste outlet must be installed in accordance with all local building codes. All drain connections must be made using an access created beneath the tub. Using the OS&B® Island Tub Drain or similar product may eliminate the need for an access panel.
PAGE 5
POST INSTALLATION CLEAN-UP Remove all construction debris from bath. Do not use wire brushes or any other metal implement on bath surface. Post installation clean-up generally can be completed using warm water and liquid dishwashing detergent. Stubborn dirt or stains may be removed using granular Spic and Span® mixed with water. Painter's naphtha can be used to remove excess adhesives and/or wet oil-base paint.