Installation Guide

AM
E
R
I
C
AN
S
T
A
N
D
AR
D
FINISHED TILE FLOOR
UNDERLAYMENT
SUB FLOOR
DRYWALL
SCREW
EVERY STUD
A
M
E
R
I
CA
N
S
T
AN
DA
R
D
Observe Local Plumbing and Building Codes
FRAMING INSTRUCTIONS
DRAIN
32
1
SAVE FOR FUTURE USE
790043-400 Rev. M
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2012
Princeton™ Bath Models:
2390, 2391, 2392, 2393
INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. Carefully unpack and
examine your new plumbing fixture thoroughly. To ensure this product is installed properly, please read these instructions
carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to
local codes.
ATTENTION
For questions, damaged or missing parts, PLEASE CONTACT AMERICAN STANDARD DIRECTLY BEFORE
RETURNING THIS PRODUCT TO THE STORE.
Please contact Customer Service: US – 800-442-1902 CANADA – 800-387-0369
We can take care of any product related question or issue you may have.
Note recess is 1527 x 762mm
(60-1/8 x 30). Cut a 229 x 305mm
(9 x 12) hole in sub floor for drain,
centered 362mm (14-1/4) as shown
for below floor rough. Locate studs
as required, then ensure rough
opening dimensions are proper and
supports are plumb and square.
*
Install stringer as shown
(346mm [13-5/8] for through the
floor drain or 435mm [17-1/8] for
above the floor drain.)
Install the overflow and
drain assembly onto the
tub per manufacturer's
instructions.
The tub is provided with an integral base for easier installation. Position the bath on the floor and slide
into place until the tub is resting on the rear stringer. The base does not need to contact the floor for
proper installation. The base on the 2392 and 2393 models is raised above the floor to facilitate drain
installation. Check level, front to back and side to side. Also check drain clearance hole in sub floor. To
secure the tub to wood studs, use sheet rock screws with washers immediately above the flange of the
tub. To secure the tub
to steel studs, use
drywall screws and
flat washers.
(See Step 4)
Caution: Take Extra
Care When Driving
Screws To Avoid
Damaging The Tub.
The tile or similar
finished floor will be
butted against the
bottom of the tub
apron also holding
the tub in place.
*
1527mm
(60-1/8)
762mm
(30)
TUB WIDTH
FULL LENGTH LEVELING SUPPORT
STRINGER 51 x 102mm (2 X 4 X 5 FT.)
APPLY BEAD OF SILICONE CAULKING
TO TOP OF LEVELING SUPPORT
STRINGER BEFORE INSTALLING TUB
362mm
(14-1/4)
229 x 305mm
(9 x 12) FLOOR
CUTOUT
FOR DRAIN
762mm
(30)
INSTALLATION - BEDDING MATERIAL (MORTAR, SANDMIX, ETC.) IS ACCEPTABLE
SUB FLOOR MUST BE STRUCTURALLY SOUND & FREE OF MOVEMENT / FLEXING