Installation Sheet

ManualsBrandsAmerican Standard ManualsPlumbingSpectra 2.5 GPM Shower System with Hand Shower, Slide Bar, and Wall Supply

- 1 -

Product names listed herein are trademarks of AS America, Inc.

Thank you for selecting American Standard...

the benchmark of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly-please read

these instructions carefully before you begin.

RECOMMENDED TOOLS AND MATERIALS

Most of the procedures require the use of common tools and materials, which are available from hardware and plumbing

supply stores. It is essential that the tools and materials be on hand before work is begun.

M965854 (8/17)

SPECTRA+ HANDHELD

™

KIT

Adjustable Personal

Hand Shower Bar

For all Models

ROUGHING-IN DIMENSIONS:

• For reference

30-1/8"

(765 mm)

1-9/16" DIA

(40 mm)

1-3/4"

(45 mm)

FINISHED

WALL

WALL SUPPLY

WITH BUILT IN

BACK FLOW

PREVENTER

1/2"

(13 mm)

1-1/16"

(26 mm)

1-7/16"

(37 mm)

1/2 N.P.T.

(13 mm)

(48" - 60") (OPTIONAL)

TO FINISHED FLOOR

(1219 - 1524 mm)

RUBBER GASKET

FINISHED WALL

1/2" NPSM HOSE

CONNECTION (13 mm)

59"

(1499 mm)

9-15/16"

(252 mm)

1-3/4"

(43 mm)

DrillFlat Blade Screwdriver Level

10'

Tape Measure

CARE AND CLEANING

Do: Simply rinse the product clean with clear water, dry with a soft cotton ﬂannel cloth.

Do Not: Clean the product with soaps, acid, polish, abrasives, harsh cleaners, or a cloth with a coarse surface.

INSTALLATION

INSTRUCTIONS

Certied to comply with ANSI A112.18.1M

Summary of content (3 pages)

PAGE 1
INSTALLATION INSTRUCTIONS SPECTRA+ HANDHELD™ KIT Adjustable Personal Hand Shower Bar For all Models Thank you for selecting American Standard... the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.1M RECOMMENDED TOOLS AND MATERIALS Most of the procedures require the use of common tools and materials, which are available from hardware and plumbing supply stores.
PAGE 2
1 INSTALL WALL ANCHORS • The ADJUSTABLE SHOWER BAR works best if secured to a wall stud or cross brace within the wall, using the SCREWS supplied. • If the ADJUSTABLE SHOWER BAR is to be installed on a tile or plaster wall the ANCHORS (1) and SCREWS (2) should be used. • Determine desired height and location (optional) and mark the top center line. Use a level to help mark the vertical center line for the two mounting locations. The distance between the two mounting holes is 30" (765 mm).
PAGE 3
2 INSTALL ADJUSTABLE SHOWER BAR • Remove CAP (1) from SHOWER RAIL (2). C/L 3 1 • Secure SHOWER RAIL (2) to the wall using MOUNTING SCREWS (3). Do not fully tighten. After alignment is made, tighten the MOUNTING SCREWS (3) fully. • Instal CAP (1) back onto SHOWER RAIL (2). 30" (765 mm) C/L 2 C/L 3 INSTALL WALL SUPPLY • Supply to WALL SUPPLY is 1/2" NPT. See rough-in above for detailed information. • Apply sealant or sealing tape to threads of 1/2" NPT supply nipple.