Quick Start Guide

Table Of Contents

Spektrum+ Smart Gateway120V

INSTALLATION INSTRUCTIONS

SPKPL-GTWY

SAFETY INFORMATION

• Read all instructions before beginning; Save these instructions for future use.

• To reduce the risk of ﬁre, electric shock, or injury to persons, pay close attention

to this manual and stay within its guidelines when using this product.

• If you are unsure about your wiring, consult a qualiﬁed electrician or local electrical

inspector, and check your local electrical code.

• There are no serviceable parts inside this gateway. Do not attempt to dismantle,

open or service this gateway in any way.

• The optimal operating temperature of this product is -10°C (14°F) to 55°C (131°F).

• Thie gateway requires a 2.4Ghz WiFi signal to operate.

• This gateway is not intended for use with a standard wall plate dimmer switch. Use

only with Spektrum+ Smart Lighting Bluetooth App or Spektrum+ handheld remote

controller (SPKPL-CTRL-W-RGBTW sold separately)

• This gateway is rated for dry/indoor locations only. Keep away from all water and

moisture.

These products may represent a possible shock or

ﬁre hazard if improperly installed or attached in any

way. Products should be installed in accordance

with these instructions, current electrical codes,

and/or the current National Electric Code (NEC).

The electrical rating of this product is 5V DC and

utilizes a 120V AC power adapter. The installer

must determine whether power supply is appro-

priate before installation. Ensure power supply is

turned o at the fuse box or circuit breaker prior to

attempting installation or servicing of the gateway.

WARNING

INSTALLATION INSTRUCTIONS:

This ﬁxture requires a 120VDC power source.

1. Place gateway within 18” of power receptacle.

2. Plug mini USB power adapter into Gateway. See Figure 1.

3. Plug power adapter into receptacle. The blue power indicator light on the Gateway will light when powered. See Figure 2.

4. Pair device to Spektrum+ Smart Lighting app on your mobile phone or tablet. For pairing instructions please refer to the Spektrum+ Smart

Lighting app guide or quick start guide.

FIGURE 1

FIGURE 2

PAGE 1
20V Spektrum+ Smart Gateway INSTALLATION INSTRUCTIONS SPKPL-GTWY WARNING These products may represent a possible shock or fire hazard if improperly installed or attached in any way. Products should be installed in accordance with these instructions, current electrical codes, and/or the current National Electric Code (NEC). WARNING The electrical rating of this product is 5V DC and utilizes a 120V AC power adapter. The installer must determine whether power supply is appropriate before installation.
PAGE 2
FCC Warning This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.