Installation Guide

Table Of Contents

ROTRF OVER-THE-ROOF FLOOR MOUNT 8000-2692-07, REV. D

INSTALLATION GUIDE

1 of 2

ROTRF Over-the-Roof

Floor Mount

For SpeedDome

Ultra or SpeedDome

Optima Outdoor Housing Mounts

Installation Guide

Regulatory Compliance: Safety UL1950

Parts Supplied

Floor Brace 1 0500-9665-01

Washer, Lock 6 5846-0500-020

Washer 6 5842-0500-020

Install Kit 0351-2144-01

Anchor, M6, Wedge w/Hardware 6 2880-0108-01

Tools Required

· Power Drill

· Hammer

· Socket Wrench Kit w/Extension (metric)

Procedure

1. Place the brace in the corner of the parapet. Mark

holes for six anchors.

2. Drill holes and install anchors according to

diagram.

3. Bolt floor brace to anchors. Then bolt over-the-

roof mount to floor brace following instructions

and hardware supplied with the mount.

Thread two nuts

back-to-back to

protect the anchor

when hammering it

into the floor.

Extend anchor threads

15mm (0.6in).

PAGE 1
ROTRF Over-the-Roof Floor Mount Procedure 1. Place the brace in the corner of the parapet. Mark holes for six anchors. For SpeedDome® Ultra or SpeedDome® Optima Outdoor Housing Mounts Installation Guide Regulatory Compliance: Safety UL1950 2. Drill holes and install anchors according to diagram. Thread two nuts back-to-back to protect the anchor when hammering it into the floor. Extend anchor threads 15mm (0.6in). 3. Bolt floor brace to anchors.
PAGE 2
Declarations Thank you for using American Dynamics products. We support our products through an extensive and worldwide network of dealers. The dealer, through whom you originally purchased this product, is your point of contact if you have a need for service or support. Our dealers are fully empowered to provide the very best in customer service and support. Dealers should contact American Dynamics at (800) 507-6268 or (561) 912-6259 or on the web at www.americandynamics.net.