9MXR User Guide and Reference Manual 10/12 6122 S. Eastern Ave. Los Angeles, CA. 90040 www.AmericanAudio.
19MXR CONTENTS MAIN FEATURES....................................................................................................................................2 ELECTRICAL PRECAUTIONS................................................................................................................3 SAFETY PRECAUTIONS........................................................................................................................5 INTRODUCTION....................................................
19MXR ELECTRICAL SAFETY PRECAUTIONS WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN, LIQUIDS, OR MOISTURE The serial and model number for this unit is located on the rear panel. Please write down the numbers here and retain for future reference. Model No._____________________________ CAUTION: DO NOT ATTEMPT TO REMOVE OR BREAK OFF THE GROUND PRONG FROM THE ELECTRICAL CORD.
19MXR ELECTRICAL SAFETY PRECAUTIONS ELECTRICAL PRECAUTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK).
19MXR 1. For adult use only - Keep out of the reach of children. 2. Water and Moisture - The mixer should not be used near water - for example, near a bath tub, kitchen sink, laundry tub, in a wet basement or near a swimming pool, etc. Do not spill water or other liquids in to or on to your mixer. 3. Ventilation - The mixer should be situated so that its location or position does not interfere with its proper ventilation.
19MXR INTRODUCTION Introductions: Congratulations and thank you for purchasing the American Audio® 19MXR mixer. This mixer is a representation of American Audio’s continuing commitment to produce the best and highest quality audio products possible at an affordable price. Please read and understand this manual completely before attempting to operate your new mixer. Please carefully read and understand the instructions in this manual thoroughly before attempting to operate this unit.
19MXR UNPACKING Every 19MXR has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have occurred during shipping. If the carton appears to be damaged, carefully inspect your mixer for any damage and be sure all equipment necessary to operate the mixer has arrived intact. In the event damage has been found or parts are missing, please contact our toll free customer support number for further instructions.
19MXR CONTROLS AND FUNCTIONS 17 1 2 16 3 15 4 14 5 13 6 12 11 7 8 9 10 FRONT PANEL ©American Audio® - www.americanaudio.
19MXR CONTROLS AND FUNCTIONS cont. 1. MICROPHONE EQ SECTION MIC 1 & 2 GAIN CONTROL - These knobs individually control the output volume of MICROPHONES 1 & 2 (1). However, master volume is controlled by the MASTER VOLUME CONTROL (14). MICROPHONE 1 & 2 TREBLE CONTROL - This knob is used to adjust the treble levels of the Microphone with a maximum signal gain of 12dB or maximum signal decrease of -12dB.
19MXR CONTROLS AND FUNCTIONS cont. access the buttons secondary command Load selected song to secondary Right deck. ENCODER & PUSH ACTION - Turn the encoder to increase or decrease the selected action. Pushing down on the encoder activates an action. See the navigation buttons for more info. UP (MIDI) - This control will set focus on the Left deck FX unit.
19MXR CONTROLS AND FUNCTIONS cont. left side of the mixer. Samples 4-6 are stored under Cue buttons 1-3 located on the right side of the board. The Controller Mode Button LED will blink when the Sampler is active. 10. MASTER VOLUME LEVEL INDICATORS - The dual MASTER LEVEL LED indicators are used to detail the master output level. The meters will detail the output level of both the left and right channels. 11.
19MXR CONTROLS AND FUNCTIONS cont. REAR PANEL 31 30 29 28 27 26 25 24 23 22 21 20 19 18 18. MICROPHONE 1 - This combo jack will accept a standard 1/4 plug or XLR 3-pin balanced male plug. The volume output level for this microphone will be controlled by its own respective MICROPHONE GAIN CONTROL (1). Note: We recommend that you use a 500-600ohm microphone for the best sound quality. 19. MICROPHONE 2 - This jack accepts a standard 1/4 plug.
19MXR CONTROLS AND FUNCTIONS cont. level input devices be sure this switch is in the “LINE” position. Always be sure main power is shut off before change the position of the Line Level Selector Switch. 24. CHANNEL 3: INPUTS - The type of input must directly reflect the selected mode of the CHANNEL LINE LEVEL SELECTOR SWITCH (23). CD players, Tape Decks and other line level instruments may be connected to these jacks.
19MXR MIDI TABLE MXR MIDI interface definition NOTE: all MIDI messages use channel 1 or channel 2(Shift), Directions OUT and IN (LED) are relative to the Mixer Control number is in decimal format All rotary VRs start at the minimum in the leftmost position and increase to the maximum when turned clockwise For all commands except LED, when in controller mode, add 2 to the channel number when Controller mode is on.
FILTER FILTER PUSH A FILTER PUSH B FILTER CH A FILTER CH B 19MXR LEFT BUTTONS CUE Left PLAY/PAUSE >|| Left HOT START 1 Left HOT START 2 Left HOT START 3 Left SYNC Left RIGHT BUTTONS CUE Right PLAY/PAUSE >|| Right HOT START 1 Right HOT START 2 Right HOT START 3 Right SYNC Right CENTER CONTROLS LOAD Left LOAD Right LEFT navigate RIGHT navigate UP navigate DOWN navigate Button / LED Button / LED Rotary VR Rotary VR 37 39 Button Button Button Button Button Button / / / / / / LED LED LED LED LE
19MXR TYPICAL MIXER SET-UP T U R N TA B L E T U R N TA B L E This image details a typical DJ Set Up consisting of a microphone, turntables, CD players, and a tape deck. Note: Turntables can only be connected to the PHONO LEVEL RCA JACKS. Be sure the LINE LEVEL SELECTOR SWITCHES are in the "PHONO" position when using turntables. ©American Audio® - www.americanaudio.
19MXR TYPICAL MIXER SET-UP Balanced XLR male to XLR female Cables American Audio V4001™ Speaker Cables Typical Balanced Output Set-up This image details a typical stereo output layout. Note the use of the Balanced XLR Jacks on both the mixer and the amplifier. Always use the balanced output jacks whenever possible. The balanced output jacks should always be used for cable runs in excess of 15 feet. Using the balanced jacks will ensure a clean signal through out the entire audio system.
19MXR CLEANING Due to fog residue, smoke, and dust, cleaning the mixer should be carried out periodically to residue build up. 1. Use normal glass cleaner and a soft cloth to wipe down the outside casing. 2. Use a cleaner specially designed for electronics to spray in and around the knobs and switch. This will reduce small particle built up that can effect the proper operation of the mixer. 3. Cleaning should be carried out every 30-60 days to prevent heavy built up. 4.
MXR TROUBLESHOOTING Trouble Shooting: Listed below are common problems you may encounter, and solutions. There is no power to the unit: Be sure you have connected the power cord to a correct wall outlet. There is little or no sound: 1. Check the input selector switch. Make sure it is set to the device that is currently playing. 2. Check to see if the connection cables are connected properly. The sound is distorted: 1. Make sure that the Gain level control is not set to high.
19MXR WARRANTY The 19MXR carries a one year limited warranty. We recommend you fill out the enclosed warranty card to validate your purchase. All returned service items whether under warranty or not, must be freight pre-paid and accompany a R.A. (return authorization) number. If the mixer is under warranty, you must provide a proof of purchase invoice. You may obtain a R.A. number by contacting our customer support team on our toll free number.
19MXR SPECIFICATIONS Model: 19MXR - 19-inch, 4-Channel MIDILOG™ Mixer POWER SUPPLY: AC 100V ~ 240V AC 50/60Hz (Universal) DIMENSIONS: 482mm (L) x 178mm (W) x 85mm (H) 19” (L) x 7.25” (W) x 3.5” (H) WEIGHT: 8 Lbs. / 3.4 Kgs.
©American Audio® World Headquarters: 6122 S. Eastern Ave. Los Angeles, CA 90040 USA Tel: 323-582-3322 Fax: 323-582-3311 Web: www.AmericanAudio.us E-mail: info@americanaudio.us American DJ Europe Junostraat 2 6468 EW Kerkrade Netherlands service@adjgroup.eu / www.americandj.