Installation Manual

ManualsBrandsAMD ManualsCPU ProcessorsAMD Ryzen 7 1700 Processor with Wraith Spire LED Cooler (YD1700BBAEBOX)

Drivers + Support

How to uninstall and install an AMD

processor and a heatsink / fan in a system

Article Number: CPU-17

This article provides step-by-step instructions on the best method to uninstall and install an AMD

processor and heatsink / fan (HSF) to ensure proper function and prevent subsequent damage to

the processor and HSF.

The article consists of the following sections:

 What to consider before performing any work in the system

 How to remove / uninstall an AMD processor and HSF

 How to install an AMD processor and HSF

What to consider before performing any work in the system

To prevent damage to the system when uninstalling or installing the processor / HSF, the

following preparations need to be considered before any work is performed to the system:

1. Ensure that the place of work provides a stable surface to allow good access to the

internal components of the system

2. Avoid working on a carpeted area, especially in cool, dry environments

3. Ensure that the system is completely turned off and unplugged from the wall outlet

4. Properly ground yourself to the case to protect against Electro Static Discharge (ESD),

which can cause damage to the processor and other sensitive system components

1. Ideally, ground yourself by using an anti-static wrist strap

1. An anti-static wrist strap or inexpensive temporary paper-type static wrist

strap can be purchased from a PC component reseller

Return to Table of Contents

How to remove / uninstall an AMD processor and HSF unit:

To remove a preinstalled AMD processor and a HSF, refer to the following instructions:

Note!

These instructions are only applicable for systems with a pre-installed AMD processor and HSF.

Summary of content (4 pages)

PAGE 1
Drivers + Support How to uninstall and install an AMD processor and a heatsink / fan in a system Article Number: CPU-17 This article provides step-by-step instructions on the best method to uninstall and install an AMD processor and heatsink / fan (HSF) to ensure proper function and prevent subsequent damage to the processor and HSF.
PAGE 2
If you do not feel comfortable with performing any of the instructions on your own, consult with an expert. 1. Remove the side panel or lid of the system’s case 2. Remove the HSF 1. Disconnect the (Molex) power cable of the HSF from the power (connector or header) connection on the motherboard 2. Turn the cam lever of the HSF to release and relieve force on the clips of the HSF and motherboard HSF bracket 1.
PAGE 3
Return to Table of Contents How to install an AMD processor and HSF unit: To install an AMD processor and a HSF, refer to the following instructions. Note!   If you do not feel comfortable with performing any of the instructions on your own, consult with an expert. Before installing the processor onto the motherboard, ensure that the processor and motherboard socket types are compatible. Failure to do so can cause damage to the processor's pins and / or motherboard's socket. 1.
PAGE 4
2. If installing a new HSF with pre-applied thermal material, remove the protective plastic film that is placed on top of the thermal material, which is located on the bottom surface of the HSF, if applicable 3. Place the heatsink on the processor with it centered in the retention frame of the motherboard and align the clips of the HSF with the retention frame anchors 4. Ensure that the clips of the HSF rest over the retention frame anchors on the motherboard 5.