AMCON AUTOMATIC CHART PROJECTOR USER’S MANUAL EQ-6002 1-800-255-6161• Fax 1-800-397-0013 www.amconlabs.
Disclaimer............................................................................................................ 2 1. Introduction...................................................................................................... 3 2. Safety Instructions.............................................................. ............................ 3 3. Charts and Specifications........................................... ................................... 4 4. Parts of the Instrument...................
Automatic Chart Projector - EQ-6002 ________________________________________________________________ DISCLAIMER Amcon, The Eyecare Supply Center makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties, merchantability, or fitness for any particular purpose.
Automatic Chart Projector - EQ-6002 ________________________________________________________________ 1. Introduction Thank you for purchasing the Amcon Automatic Chart Projector. Please read this instruction manual and keep it in a convenient location for future reference. The remote controlled Amcon Automatic Chart Projector is used to test visual acuity. The Amcon Automatic Chart Projector provides operational convenience in a high quality instrument. 2.
Automatic Chart Projector - EQ-6002 ________________________________________________________________ 3.
Automatic Chart Projector - EQ-6002 ________________________________________________________________ Binocular Vision Testing Charts: Refraction distance 5 ft – 20 ft Projection distance 5 ft – 20 ft Projection magnification 30X (at 20 ft refraction) Number of charts 30 Chart changeover 1 frame / 0.3 sec. Mask changeover 1 frame / 0.1 sec. Bulb 12V 50W (Halogen) Replacement bulbs available from Amcon Product number: RQ-6200 Electricity AC 110V 60Hz Power consumption 80W Weight 13 lbs.
Automatic Chart Projector - EQ-6002 ________________________________________________________________ 4. Parts of the Instrument 4.1 Projector Parts 1) Top Cover 2) Remote Sensor 3) Front Panel 4) Lamp Cover 5) Barrel Screw 6) Projection Window 7) Base 8) Power Switch 9) Power Socket 1 4.
Automatic Chart Projector - EQ-6002 ________________________________________________________________ 5. Operating Procedures Caution: Do not tilt the projector or place in an unstable place. The projector may topple over, drop or cause injury. Warning: Connect the power plug to a properly grounded three-prong AC outlet. If it is connected to an ungrounded outlet, fire and/or electrical shock may result. Caution: Handling the power plug with wet hands can cause electric shock. 5.
Automatic Chart Projector - EQ-6002 ________________________________________________________________ 5.3 Using the Program Function Accessing the Programming Mode a) Turn on the power switch. The projector goes into initialization state. b) Press the “RESET” button on the remote control. c) Press the “R and G filter” button on the remote control. d) Press the “Reset” button again on the remote control. The projector will beep twice after pressing each button in “1b, 1c, 1d”.
Automatic Chart Projector - EQ-6002 ________________________________________________________________ 6. Maintenance and Care 6.1 Daily Maintenance • • • • Cover the projector when not in use. This instrument is sensitive to dust contamination. Turn the power switch off when not in use. It is also recommended to unplug this instrument when not in use for longer periods of time. Keep projector clean by wiping the outside panels with a dry cloth.
Automatic Chart Projector - EQ-6002 ________________________________________________________________ Turn the power switch off and disconnect the power supply plug. The fuse holder is located just below the power supply socket. Pull on the fuse holder to remove it. The fuse will be removed together with the holder. Remove the blown fuses and insert the new fuses on the cap of the fuse holder and install it as before. 6.
Automatic Chart Projector - EQ-6002 ________________________________________________________________ 7. Troubleshooting Warning: Do not break down, modify or repair the equipment. Doing so can cause electric shock. Request a repair from your dealer. Check the situations covered in the following table for the problem you are experiencing. If your situation is not covered or if the recommended action does not solve the problem, contact your dealer for further support.