Manual BlueNiceCom III V1.4 Stand November 2004 AMBER wireless GmbH Albin-Köbis-Straße 18 51147 Köln Tel. 02203-6991950 Fax 02203-459883 eMail info@amber-wireless.de Internet www.amber-wireless.
Inhaltsverzeichnis 1 Allgemein .......................................................................................Fehler! Textmarke nicht definiert. 2 Technische Daten:.........................................................................Fehler! Textmarke nicht definiert. 3 Anschlussbelegung :..........................................................................................................................4 4 Abmessungen: ........................................................................
1 General BlueNiceCom III Bluetooth-Modul with UART-interface and integrated Chip-antenna • Bluetooth Class 2 Modul • Serial Port Profile (SPP) • UART interface • Integrated chip-antenne • GAP & SDP support AMBER wireless provides with the BlueNiceCom III a Bluetooth-module with an integrated chipantenna, based on LMX9820 from National Semiconductor. This compact and inexpensive Bluetoothversion is qualified for a serial data transmission.
3 Pin assignment : Antenne Pin Nr.
4 Dimession: BlueNiceCom III has 1mm x 2mm soldering pads with a raster of 2mm to be solder direct on a motherboard. Stand November 2004, Version 1.4 Technische Änderungen vorbehalten AMBER wireless GmbH, Tel. 02203-6991950, Fax 02203-459883 Email info@ amber-wireless.de Internet www.amber-wireless.
5 Details for Layout: To achieve the maximum of range no metall has to be near or under the antenna. The antenna should have a distance of 8mm to any gound, strip line or component. Most suitable is to place the antenna at the margin of the motherboard. The figure shows the area which should be free of metal (ground, strip line, components, etc..). The area off 12mm between the soldering pads on the bottom side should (e.g.
Abbildung 1: Bluenicecom III Abbildung 2: Vorschlag for Footprint Further range of products around BlueNiceCom II: Bluetoothmodules: BlueNiceCom I & II & III Evaluation-Kit: 1 BlueNiceCom II module; 1 2,4GHz antenna; 1 RS232 board with Sub-D-9 connector and LED´s; batteries for power supply; 1 USB-Bluetoothmodule for a second station – to build up a Bluetooth radio link immediately, documentation and software. Software-Tools: C-Tools for controlling the LMX9820.
