Step 1: A. F. Before you start assembly make sure components listed below are in the package. D. R A D I A N T Step 2: Insert plastic bush (F) in tube (D). H A R D W I R E D D. Step 3: I. Using screw (A) attach the tube to the nut on the back of the frame with allen key (I). Step 4: wire cover tube Page 1 F. Place the cover plate over the wire cover tube and position it so that it fits junction box.
Step 5: H A R D W I R E D Page 2 E. Insert metal bushing (C) in each tube and place frame against wall. Make sure the frame is level and that the wall plate provided is lined up with the junction box on the wall. Step 6: Using a pencil, mark the position of the bushings on the wall. ) 8 mm 6 5 r 8 " (o 22 3/ C. 15 1/4 "(or 388 mm) R A D I A N T C. B. Step 7: Remove bushings (C) from tube and using the screws (B) fix the bushings to the wall.
Step 8: G R A D I A N T Mount the frame onto the bushings (C) that are fixed to the wall and make sure the tubes are flush against the bushing. Step 9: E H A R D W I R E D Step 10: Plastic caps Attach the cover plate (I) to the wire cover tube. Make sure the power is disconnected and then connect the electrical wires in the junction box. Step 11: Switch Page 3 Tighten all the set screws (E) with the allen key (G). Do not over tighten. Make sure frame is firmly fixed to wall.
R A D I A N T P L U G I N FOR PLUG IN MODELS THE UNIT IS SUPPLIED WITH A cULus LISTED CORD WITH GROUNDED PLUG. INSTALLATION IS THE SAME AS THE HARDWIRED MODEL, EXCLUDING: STEPS 4, 10 AND 11. THE UNIT MUST BE PLUGGED INTO AN OUTLET THAT IS GROUNDED.