User's Manual

User’s Manual
Since this module is not sold to the general end users directly, and is designed, limited for use and incorporated
into an end product or host device by the grantee (Amazon Robotics LLC), there is no user’s manual for the
module.
Once incorporated into the end product or host device, the module is hard-coded and cannot be overwritten
(read-only) thus full compliance is assured.
For details about the module, please refer to the engineering specification sheet of the module.
The User Manual and Users Notice shall be in English and in French (when available).
The User’s Manual shall contain the following information.
End Product Labeling and Manual Requirements
The following information must be visible and displayed on the end product.
 “Contains FCC ID: 2AEZR-XUI”
 “Contains IC: 10244A-XUI”
 ”This device complies with Part 15 of the FCC Rules and Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.”
“Le présent appareil est conforme à la partie 15 des règles de la FCC et CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'appareil doit accepter tout brouillage
subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.”
Note: If it is difficult to print the above statement on the end product or host device due to size, then the statement shall be printed
in the end product/host device user’s manual.
The user’s manual shall contain the following statement cautioning the user that;
 “This device must not be collocated or operating in conjunction with any other antenna or transmitter.”
 “Changes or modifications not expressly approved by Amazon Robotics LLC could void the user’s
authority to operate the equipment.”
 This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.