Safety Instructions

ManualsBrandsAMAX INDUSTRIAL GROUP CHINA ManualsElectronicsAir RACER2.0

V 1.0

Made in China

CHOKING HAZARD

Small parts.

Not suitable for children under 3 years.

WARNING!

WARNING: Never leave product charging unattended for extended periods of

time. Always disconnect the battery from charger immediately after the battery

is fully charged. Please refer to enclosed safety instructions.

INSTRUCTION BOOKLET

PACKAGE CONTAINS:

Colors and styles may vary.

FCC Part 15 C Notice

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

2.4G Wireless Controller Instruction ManualSpare Parts

AIR RACER™ 2.0

USB Charger

& Li-Poly

Rechargeable Battery

Conforms to safety requirements of FCC.

This product is manufactured by AMAX Group

12645 Memorial Drive Suite F1 #388 Houston, TX 77024

Propel™ and Propel RC™ are the licensed trademarks of Rooftop Group

LTD Singapore.

FPO

ARTWORK NO. DESCRIPTION MDSER DESIGNER DATE

114 x 174MM Johnny 2019/05/22

Indoor / Outdoor Laser Battling Drones

AIR RACER

™

2.0

Summary of content (7 pages)

PAGE 1
AIR RACER™ 2.0 FCC Part 15 C Notice CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 2
TABLE OF CONTENTS Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Remote Control Battery Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Charging the Battle X’s Li-Poly Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 AIR RACER™ 2.0 Battery Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PAGE 3
AIR RACER™ 2.0 DIAGRAM WARNING Safety Guard DO NOT FLY YOUR AIR RACER™ 2.0 IN FOUL WEATHER! Rotor Blades FLIGHT PREPARATION Replaceable Battery • Verify that there are 3 “AA” batteries installed the remote control unit and the AIR RACER™ 2.0 battery has been fully charged. • Make sure to be in a large open space preferably a field or a park with an open radius of at least 200 feet. • Make sure to start your drone on a clean flat level surface before take-off.
PAGE 4
NOW YOU ARE READY TO FLY! If you have successfully synced your AIR RACER™ 2.0 to your controller as explained on page 4 you are now ready to fly. Before beginning to fly your drone you should familiarize yourself with how the controls work so please carefully read and familiarize yourself with various control features explain in the next two pages. Once again as a beginner pilot you should learn how to control your drone in a large open field or park on a day with zero or very light wind.
PAGE 5
ADJUSTING THE TRIM CALIBRATING THE AIR RACER™ 2.0 NOTE: The AIR RACER™ 2.0 is already properly trimmed and calibrated right out of the box and should not require any trim adjustments before flying. Some more experienced pilots may want to adjust trim settings for their style of flying. After several crashes you may need to adjust trim settings for the AIR RACER™ 2.0 to be more balanced. Forward/Backward Trim • If your AIR RACER™ 2.
PAGE 6
HOW TO PERFORM 360º STUNT FLIPS Performing 360º stunt flips with the AIR RACER™ 2.0 is as easy as 1-2-3: 1. Hover the AIR RACER™ 2.0 in still position making sure that you have at least 5 feet of clearance above and below the quadrocopter,. 2. Press and release the 360˚ stunt button and you will enter the stunt flip mode the controller will start beeping. (see diagram Q1). 3.
PAGE 7
AIR RACER™ 2.0 WARNING: The AIR RACER™ 2.0 is designed for indoor & outdoor use. The Battle X’s blades revolve at high speeds and can cause damage to the user, spectators and animals. Stand away from the AIR RACER™ 2.0 to reduce the risk of getting into the flight path. Warn spectators that you will be flying your AIR RACER™ 2.0 so that they are aware of its position. Before flight, inspect the rotor blades to make sure that the blades are securely fastened to the AIR RACER™ 2.0.