Instruction Manual

Thank you for choosingPOWER CRAZE™. With proper care, your new
POWER CRAZE™ will provide you with many hours of enjoyment. Please read this
instruction manual completely before using the product for the first time, and then
keep this manual in a handy place for future reference.
Colors and styles may slightly vary.
8
SAFETY WARNINGS!
•
Improper use of batteries may lead to overheating, breakage or leaking.
-
Do not mix old and new batteries.
-
Do not mix different battery brands.
-
Install batteries with correct polarity. The flat side (negative terminal) of the battery should rest
against the spring.
-
Remove dead batteries immediately.
-
Avoid liquids, which can short circuit the batteries.
-
The truck or remote will become unresponsive when batteries are low, at which point you should replace
all batteries with new ones.
-
Remove the batteries if you will not use the truck for a long time.
•
Avoid using near furniture or glass to prevent damage to these objects.
•
Do not play on roads.
•
Do not play in crowded areas to avoid injury or damage. Choose a safe location away from traffic.
•
Do not use truck during a storm or when lightning or thunder are present.
•
Do not use in a wet , sandy or muddy environment as truck may become damaged.
•
Do not modify or attempt to replace the built-in original antenna on the remote or truck. Doing so will damage the
set and affect operation.
• Do not pull on any wires that are part of the truck. Such action may cause the wires to break and the truck
to malfunction.
• Keep fingers, hair and clothes away from the truck’s spinning tires. Failure to do so may result in
physical injury.
• Never aim the truck at other people.
• Do not throw the truck or purposely hit it with any object.
• Store truck in a cool environment, away from high-temperature sources such as fires, stoves, radiators, etc.
• This truck has no user-serviceable parts. Do not attempt to modify components or circuit board.
FCC Part 15 C Notice
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class C digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
•
Consult the dealer or experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
INSTRUCTION MANUAL
Conforms to safety requirements of ASTM, FCC,RSS210 and CPSIA.
This product is manufactured by Amax Group
12645 Memorial Drive Suite F1 #388 Houston, TX 77024
Power Craze™ is the registered trademark of Amax Group
2008 All rights reserved. Visit us at www.amaxbrands.com
INDUSTRY CANADA NOTICE: CANADA ONLY.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter dout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Made in China
CT-2022
CA
CAN ICES-3 (B)/NMB-3(B)
This product meets the applicable Innovation, Science and Economic Development Canada technical
specifications.
Ce produit répond aux spécifications techniques pertinentes d'Innovation, Science et Développement
économique applicables.
Limited 90-Day Warranty NORTH AMERICA
AMAX Group USA warrants to the original consumer that this product is free from any
electrical or mechanical defects for a period of 90 DAYS from the date of purchase. If any such
defect is discovered within the warranty period, AMAX Group USA will repair or replace the
unit free of charge upon receipt of the unit, shipped postage prepaid and insured to our
warranty center. The warranty covers normal consumer use and does not cover damage that
occurs in shipment or failure that results from alterations, accident, misuse, abuse, neglect,
wear and tear, inadequate maintenance, commercial use or unreasonable use of the unit.
Removal of any parts/components voids all warranties. This warranty does not cover cost of
repairs made or attempted outside by third-party individuals or companies. Any applicable
implied warranties, including warranties of merchantability and fitness, are hereby limited to
90 DAYS from the date of purchase. Consequential or incidental damages resulting from a
breach of any applicable express or implied warranties are hereby excluded. Some states do
not allow limitations on the duration of implied warranties and do not allow exclusion of
incidental or consequential damages, so the above limitations and exclusions in these
instances may not apply.
REPAIR/REPLACE PRODUCT
If your product begins to malfunction or stop working, immediately email our warranty
center at the email listed below. If it is determined that a return is necessary, our warranty
department will issue you an RMA number/form and an address to the nearest return center
for shipping the product to. IMPORTANT NOTICE: We will reject all returns that are not
accompanied by an issued RMA form and number so make sure to contact our warranty
center before attempting to return your product!
PREPARATION FOR SHIPPING YOUR PRODUCT
Please repack your product in a durable box, preferably in the original carton, and send it
prepaid, and adequately insured. Include the RMA form that was issued by our warranty
department along with your daytime telephone number and email address inside the
shipping carton. If your warranty has expired, contact our warranty center for charged service.
For further information please send all inquiries to:
[e-mail]
IMPORTANT NOTICE!
DO NOT ATTEMPT TO SHIP YOUR PRODUCT BACK WITHOUT FIRST
CONTACTING OUR WARRANTY DEPARTMENT BY EMAIL AT:
[e-mail]