/N\ Alpha mount TV Wall Mount | suction Manual 6066866606606] Supermodel Thank you for choosing this Alpha mount product! At Alpha mount we strive to provide you with the best quality products and services in the industry.
IMPORTANT SAFETY INFORMATION *Check package contents against Supplied Parts and Hardware List to assure that all components wear received undamaged. Do not use damaged or defective parts. If you require replacement parts, contact customer service at *Not all parts and hardware Included will be used. *Carefully read all instructions before attempting installation.
Supplied Hardware Hardware for Attaching TV Brackets to TV Spacers Op washer © [If necessary] me/m8 2.5mm 10mm 22mm OD TV Bolts [Only one bolt size fits your TV] M6 Mex 15mm x4 M6 x 35mm x4 M8 mMsx25mm x4 MB x 35mm x4 MS x 50mm x4 Hardware for Attaching the Wall Plate to Wall Lag Screw ‘Washer Wall | STBX65 Ma Anchor A CAUTION! This anchor is for concrete or brick walls ONLY. DO NOT use them in drywall or wood studs.
EXXON] Check TV Hole Patter and Select TV Bolts 100 200 300 400 600 mm = 23 6/10 In.
Too Short Too Long [1.1 Secure the TV Brackets to Your TV Assemble the Wall Plate Assemble the wall plate [01] and [02] with the per-assembled bolts [S]. i Tighten ZT DO NOT over tighten.
Secure the Wall Plate [01] and [02] to Wall For wood stud Installation, follow STEP 5A For concrete installation, follow STEP 5B Step 5A Wood Stud Option A WARNING: @Moldavia potential personal Injury or property damage! DO NOT over-tighten the lag screws [A1]. Tighten the lag screws [A1] only until the washers [A2] are pulled firmly against the wall plate [01] and [02].
(2 Drill 4 pilot holes using a diameter drill bit. Make sure the depth Is not less than 2 Install the wall plate using lag screws [A1] and washers [AZ]. Tighten the lag screws [A1] only until the washers [A2] are pulled firmly against the wall plate [01] and [02]. Socket Wrench [53 C131: Solid Concrete or Concrete Block Option A WARNING: @®Avoid potential personal injury or property damage! DO NOT over-tighten the lag screws [A1].
Position the wall plate at your desired height, level the wall plate and mark the pilot hole locations. Drill 4 pilot holes using a diameter drill bit. Make sure the depth is not less than 2 Never drill Into the mortar between blocks. 2 ZI 7 Use the hammer to knock anchors [A3] Into the wall. Be sure the anchors [A3] aro seated flush with the concrete surface. Install the wall 7 plate using lag screws [A1], washers [A2] and anchors [A3].
£531. X: 1 Secure the TV onto the Wall Plate Locking A hi HEAVY! You may need [19 assistance with this step. To Hang TV onto Wall Plate 1. Hang the TV with TV brackets [03] and [04] onto the wall plate [01] and [02]. 2. While pulling the rope down, press the bottom of the TV Into the wall piste [01] and [02] | until the latches lock the TV brackets [03] and [04], then rel sass ths rope. | To Remove TV from Wall Plate | Pullet rope down to release the latches so as to remove TV from wall plate.
Thank you again for choosing this Alpha mount product! All of us at Alpha mount do appreciate your product purchase. We hope that you are as happy with your product as we are designing and manufacturing it for you. We strive to provide you with the best quality products and services in the industry.