User's Manual

Allremote Wireless Technology, 2006/12/20 1

RRC065A User Manual

1.) Into Duplication Mode:

Make sure “”SW” is on “UP” position.

Press and hold all buttons on RRC065A, blue LED flashing 3 times shortly and 3 seconds

later will light on still, now please releasing buttons. It Had into Duplication Mode now.

2.) Duplicating Code:

2-1. Please be sure RRC065A had in Duplication Mode.

“SW” has to be on “up” position then press any one of

RRC065A button still, Blue LED will keeping flashing.(It

means that in real Duplication situation)

2-2. Releasing all buttons, and please push “SW” to the

down position.

2-3. Please take original remote and press button still also,

close to RRC065A right side to find and searching till

RRC065A red indicator LED indicating more brighter, It

means to the best duplicating position. then press desire button on RRC065A blue LED

will flashing once (It means done), what if blue LED keeping flashing or not light off.(It

means fail), please go back procedure 2-2.

2-4. Push SW1 up.

3.) Finishing Duplicating:

3-1. press all RRC065A together till blue LED flashing once, it means all Done and can be

used.

3-2. What if duplication & set up fail,(Can not remote by RRC065A ),please repeat

procedure 1.) 2.) and 3.) once again.

※ Normally press any RRC065A button, it emits including 4 type Frequency (390MHz /

318MHz / 310MHz / 300MHz) Main receiver will operate in 5 seconds, if you need to

re-emitting signal by RRC065A , Please releasing all buttons after blue LED light’s off and

repress once again.

GENIE’S Garage Door operation

1.) Following same way with RRC065A Duplication Mode, Duplicating Genie’s

Remote unit code into RRC065A.

2.) Please Following Genie’s Original User Manual, and learning RRC065A as

new group for setting up.

PAGE 1
RRC065A User Manual 1.) Into Duplication Mode: Make sure “”SW” is on “UP” position. Press and hold all buttons on RRC065A, blue LED flashing 3 times shortly and 3 seconds later will light on still, now please releasing buttons. It Had into Duplication Mode now. 2.) Duplicating Code: 2-1. Please be sure RRC065A had in Duplication Mode. “SW” has to be on “up” position then press any one of RRC065A button still, Blue LED will keeping flashing.(It means that in real Duplication situation) 2-2.
PAGE 2
4.) Every single Genie’s Garage Main receiver only acceptance 2 pcs RRC065A Maximum to learn into on each different remote button. For Example, When you learn into first RRC065A on button A, The second RRC065A must on button B. ※ GENIE’S Main Receiver Learning Mode. Press once learning button of Main receiver, The LED indicator will keeping flashing, then press RRC065A face toward to main receiver. When Main receiver catch the signal the LED is becoming light on still.
PAGE 3
FCC approved, ID No. OAVRRC065A This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Notice : The changes or modifications not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment.