User's Manual

ManualsBrandsAltrusty ManualsElectronicsSelf Learning Duplicator

Created by Allremote Wireless Technology 2005/8/10 1

RRC001A Duplication Manual

1. Enter Duplication mode:

Press Button 1 & Button 3 simultaneously and keeping pressing 1 & 3 buttons on the

RRC001A

, LED indicator will constantly flashing three times, and still hold these two

buttons for 6 seconds, then LED indicator will flashing two times shortly. At this moment

release both button then has into “ enter duplication mode” .

2. Duplicate CODE:

a. To make sure RRC001A in the “ enter duplication model ” , just pushed - still any key

if LED indicator is flashing constantly that means in duplication mode.

b. Place the Original one and next to RRC001A

right side press it first, Then press the

RRC001A

which one you willing to define compare to the original one button quickly

after the original one, It will flash 1 time shortly, (it duplicated successfully), what if

LED keeps flashing (the duplicating failed), please repeat step b.

3. Duplicating Terminated:

a. Press RRC001A Button 1 & Button 3 simultaneously, LED indicator flash once then

goes off and you can use it.

Summary of content (4 pages)

PAGE 1
RRC001A Duplication Manual 1. Enter Duplication mode: Press Button 1 & Button 3 simultaneously and keeping pressing 1 & 3 buttons on the RRC001A, LED indicator will constantly flashing three times, and still hold these two buttons for 6 seconds, then LED indicator will flashing two times shortly. At this moment release both button then has into “enter duplication mode”. 2. Duplicate CODE: a.
PAGE 2
b. If duplicate failed, please repeat 1, 2, 3, step. c. The each buttons of RRC001A, can copy each individual variety code. ＊ In normal state, press down RRC001A any key, it will launch 300MHZ; 310MHZ and 390MHZ take turns in 3 frequency, if want to launch second time, have to release the button and start over again. A. For Genie Intellicode / GMI-3BL Garage Door Remote Controls (programming applicable to buttons 1, 2, 3 and 4) A 1.
PAGE 3
RRC001A just can only be duplicated 2 individual remote codes. To the any 2 individual buttons on RRC001A . and the One original Genie Intelligent remote Code needs to be programmed into different buttons on either RRC001A . A 4. Programming RRC001A with the Genie Intellicode / GMI-3BL Receiver:  Garage Door Aim the RRC001A close to the Receiver Unit in your garage. Press the button (learning actuator) on your Garage Door Receiver Unit, and it should begin flashing.
PAGE 4
Notice : The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. THIS DEVICE COMPLIES WITH PART 15 OF THE FCCRULES. OPERATIONS IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: ( 1 ) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND ( 2 ) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFEERENCE THAT MAY CAUSE UNDESRIED OPERATION.