Installation Instructions

ManualsBrandsAltronix ManualsIndoor wallmount16 Output Power Supply/Charger - 24VDC

Rev. 071212

SMP10PM24X Series

Power Supply/Chargers

Installation Guide

Models Include:

SMP10C24X SMP10PMC24X

- 24VDC @ 10 amp total supply current. - 24VDC @ 10 amp total supply current

with supervision.

SMP10PM24P4 SMP10PM24P4CB

- 24VDC @ 10 amp total supply current - 24VDC @ 10 amp total supply current

with supervision. with supervision.

- Four (4) fuse protected outputs. - Four (4) PTC protected outputs.

SMP10PM24P8 SMP10PM24P8CB

- 24VDC @ 10 amp total supply current - 24VDC @ 10 amp total supply current

with supervision. with supervision.

- Eight (8) fuse protected outputs. - Eight (8) PTC protected outputs.

SMP10PM24P16 SMP10PM24P16CB

- 24VDC @ 10 amp total supply current - 24VDC @ 10 amp total supply current

with supervision. with supervision.

- Sixteen (16) fuse protected outputs. - Sixteen (16) PTC protected outputs.

Summary of content (8 pages)

PAGE 1
SMP10PM24X Series Power Supply/Chargers Installation Guide Models Include: SMP10C24X SMP10PMC24X - 24VDC @ 10 amp total supply current. - 24VDC @ 10 amp total supply current with supervision. SMP10PM24P4 SMP10PM24P4CB - 24VDC @ 10 amp total supply current - 24VDC @ 10 amp total supply current with supervision. with supervision. - Four (4) fuse protected outputs. - Four (4) PTC protected outputs.
PAGE 2
Overview: These units convert a 115VAC 60Hz input into a regulated 24VDC @ 10 amp continuous supply current (see specifications). • Input 115VAC, 60Hz, 2.7 amp. Output: 24VDC output. 10 amp supply current. Filtered and electronically regulated outputs. Short circuit and thermal overload protection. Battery Backup: • Built-in charger for sealed lead acid or gel type batteries. • Maximum charge current 0.7 amp. • Zero voltage drop when switching over to battery backup.
PAGE 3
4. Connect devices to be powered: a. For Power Supply Board connect to the terminals marked [--- DC +]. b. For Power Distribution Module(s) connect devices to be powered to the terminal pairs 1 to 4 marked [1P & 1N] through [4P & 4N] (Fig. 2, pg. 4), 1 to 8 marked [1P & 1N] through [8P & 8N] (Fig. 3, pg. 4), or 1 to 16 marked [1P & 1N] through [16P & 16N] (Fig. 5, pg. 5) carefully observing correct polarity. 5. When using stand-by batteries, they must be lead acid or gel type.
PAGE 4
OFF ON Divider 5A 250V CAUTION: De-energize unit prior to servicing. For continued protection against risk of electric shock and fire hazard replace fuse with the same type and rating 5A, 250V. Fig. 1 OFF Green Lead ON Divider AC FAIL Power Distribution Module C NO NC C NO NC 15 power mains Class 1 115 power mains Class 1 Door AC FAIL Earth Ground NC Fig.
PAGE 5
OFF ON Divider 5A 250V CAUTION: De-energize unit prior to servicing. For continued protection against risk of electric shock and fire hazard replace fuse with the same type and rating 5A, 250V. Fig. 4 OFF ON Green Lead Divider NC C AC FAIL AC FAIL C NO 115 power mains Class 1 Power Distribution Module NO NC LOW BAT Door AC DC C NO 15 power mains Class 1 Green Lead NC Fig.
PAGE 6
Enclosure Dimensions (H x W x D approx.): 13.5” x 13” x 3.25” (342.9mm x 330.2mm x 82.55mm) Enclosure accommodates up to two (2) 12VDC/7AH batteries. 1.40” (36mm) 4.85” (123mm) 4.85” (123mm) 1.40” (36mm) 1.20” (31mm) 3.25” (83mm) 1.20” (31mm) 0.75” (19mm) 12.5” (318mm) 11.0” (279mm) 1.20” (31mm) 0.75” (19mm) 0.9375” (24mm) 1.40” (36mm) 1.40” (36mm) 5.10” (130mm) 5.10” (130mm) 13.0” (330mm) 5.10” (130mm) 6.5625” (167mm) 0.9375” (24mm) 3.25” (83mm) 3.25” (83mm) 3.25” (83mm) 1.0” (25mm) 1.
PAGE 7
Notes: SMP1024Xseries - 7 -
PAGE 8
Notes: Altronix is not responsible for any typographical errors. Product specifications are subject to change without notice. 140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: 718-567-9056 web site: www.altronix.com, e-mail: info@altronix.com, Made in U.S.A. IISMP10C24X - Rev.