Cut Sheet

Specifications
Input:
Input 115VAC, 60Hz, 3.5 amp.
Output:
12VDC or 24VDC selectable output.
6 amp continuous supply current.
Filtered and electronically regulated output.
Short circuit and thermal overload protection.
Battery Backup:
Built-in charger for sealed lead acid or
gel type batteries.
Automatic switch over to stand-by battery
when AC fails.
Maximum charge current 0.7 amp.
Supervision:
AC fail supervision (form “C” contacts).
- Notification trigger is selectable for
30 seconds (factory set) or 6 hours.
Supervision (cont’d):
Low battery supervision (form “C” contacts).
Battery presence supervision (form “C” contacts).
Visual Indicators:
AC input and DC output LED indicators.
Electrical:
Operating temperature: 0º C to 49º C ambient.
36.85 or 73.70 BTU/Hr.
System AC input VA requirement: 402.5VA.
Mechanical:
Enclosure Dimensions (H x W x D approx.):
13.5” x 13” x 3.25” (342.9mm x 330.2mm x 82.55mm)
- Accommodates up to two (2) 12VDC/7AH batteries.
Product weight (approx.): 7.6 lbs. (3.45 kg).
Shipping weight (approx.): 8.5 lbs. (3.86 kg).
AL600ULX is a power supply/charger which converts a 115VAC/60Hz input
into a single 12VDC or 24VDC non power-limited output.
AL600ULX
Power Supply/Charger
Rev. DSAL600ULX_04222015
Overview
AL600ULX
Agency Approvals
UL 294 UL Listed for Access Control
System Units.
UL 1481 UL Listed Standard for Safety for
Fire Protective Signaling Systems.
MEA - NYC Department of
Buildings Approved.
CSFM - California State Fire
Marshal Approved.
Altronix Corp.
140 58th St. Brooklyn, NY
General Signaling Equipment
Evaluated to CSA Standard C22.2
No.205-M1983

Summary of content (2 pages)