ACM8E and ACM8CBE Access Power Controllers Installation Guide Models Include: • ACM8E - Eight (8) Fuse Protected Outputs • ACM8CBE - Eight (8) PTC Protected Outputs Rev.
Overview: These units convert one (1) 12 to 24 volt AC or DC input into eight (8) independently controlled fused or PTC protected outputs. These power outputs can be converted to dry form “C” contacts (ACM8E only). Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc.
Installation Instructions: 1. Mount unit in the desired location. Carefully review: Typical Application Diagram (pg. 4) Terminal Identification Table (pg. 5) LED Diagnostics (pg. 5) Hook-up Diagrams (pg. 6) 2.
Typical Application Diagram: Fig. 1 Fig. 1a Keypad Normally Open N.O. Door Releasing Device (Fire Alarm Control Panel) NO NO C NC FACP Output Relay FACP Dry Form "C" Output FACP C Fire Alarm System Power Supply Unit Also suitable for use as a Access Control System Unit Subassembly. 39BA Refer to Installation Instructions IIACM8 - REV.
LED Diagnostics: LED ON LED 1 - LED 8 (Red) Output relay(s) energized. Trg (Green) FACP input triggered (alarm condition). OFF Output relay(s) de-energized. FACP normal (non-alarm condition). Terminal Identification: Terminal Legend - Power + - Control + TRIGGER INPUT 1- INPUT 8 IN, GND OUTPUT 1OUTPUT 8 NC, C, NO, COM FACP INTERFACE T, + INPUT -FACP INTERFACE NC, C, NO ACM8E / ACM8CBE Function/Description 12VDC or 24VDC input from power supply board.
Hook-Up Diagrams: Fig. 2 Optional hook-up using two (2) isolated power supply inputs: Fig. 3 Polarity reversal input from FACP signaling circuit output (polarity is referenced in alarm condition): CUT JUMPER J3 CUT JUMPERS J1 AND J2 J2 ISOLATED POWER INPUT 12 OR 24 VAC OR VDC (ACM8 POWER) J1 INTERFACE J3 TRG Fig. 4 Normally Open - Non-Latching FACP trigger input: Fig. 5 Normally Open FACP Latching trigger input with reset: (This output has not been evaluated by UL) J3 INTERFACE J3 TRG N.O.
Enclosure Dimensions: 15.5” x 12” x 4.5” (393.7mm x 304.8mm x 114.3mm) 1.5” (38.1mm) 4.615” (117.22mm) 4.615” (117.22mm) 1.5” (38.1mm) 1.75” (44.45mm) 1.375” (34.925mm) 1.125” (28.575mm) 1.25” (31.75mm) 4.5” (114.3mm) 12.23” (310.64mm) 1.1” (27.94mm) 0.91” (23.114mm) 1.5” (38.1mm) 4.5” (114.3mm) 1.1” (27.94mm) 1.25” (31.75mm) 0.91” (23.114mm) 2.0” (50.8mm) 1.5” (38.1mm) 15.5” (393.7mm) 2.0” (50.8mm) 5.0” (127.0mm) 5.0” (127.0mm) 1.1” (27.94mm) 1.25” (31.75mm) 0.79” (20.06mm) 1.
Notes: Altronix is not responsible for any typographical errors. 140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: 718-567-9056 web site: www.altronix.com, e-mail: info@altronix.com, Lifetime Warranty, Made in U.S.A.