Owner’s Manual DXFRS265 TWO-WAY RADIO MODEL Printed in China Part No. AL-ML English IF YOU HAVE QUESTIONS OR COMMENTS, CONTACT US.
ENGLISH Before operating the radio, please read all safety and operating instructions. Save all instructions in a safe place for future reference. Fig. 1 20 Definitions: Safety Alert Symbols and Words 19 This instruction manual uses the following safety alert symbols and words to alert you to hazardous situations and your risk of personal injury or property damage. 1 16 DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
ENGLISH WARNING: Important Safety Instructions 1. Only accessories included in this package or specified by the manufacturer should be used with the radio. The 5V micro-USB charging input is compatible with most high quality micro-USB chargers that fully conform to the USB standards. 2. Do not use cleaners or solvents to clean the exterior of the radio. Use only a damp or dry cloth. 3. Do not attempt to service the radio yourself. Removing the cover will void the warranty.
ENGLISH • Limit the amount of time you use headsets or earpiece at high volume levels. Important • When using the radio without a headset or earpiece, do not place the radio’s speaker directly against your ear. NEVER short the terminals of the battery pack. DO NOT push the PTT button when not actually desiring to transmit. DO NOT modify the transceiver for any reason. AVOID using or placing the transceiver in direct sunlight or in areas with temperatures exceed –20° C ~ +50° C / –5° F ~ +120° F.
ENGLISH (FCC) adopted RF exposure guidelines with safety levels for handheld wireless devices Important FCC RF Exposure Requirements: For body-worn operation, this radio has been tested and meets the FCC RF exposure guidelines when used with DEWALT accessories supplied or designated for this product. Use of other accessories may not ensure compliance with FCC RF exposure guidelines. Use only the supplied antenna.
ENGLISH Caring for Your Radio Your radio will give you years of trouble-free service if cared for properly. Handle the radio gently. Keep the radio away from dust. Never put the radio in water or in a damp place. Avoid exposure to extreme temperatures. Installing Batteries (Battery already pre-installed) To install or replace batteries: Fig. 3 1. Remove Belt clip by releasing the belt clip latch and slide the Belt clip upward (Fig. 3). 3.
ENGLISH Quick Start Fig. 10 1. Turn On/Off VOL Knob (Fig. 10) clockwise to turn the radio on and counter clockwise to turn the radio off. 2. Select a desired channel. Note: Both radios must be tuned to the same channel/privacy code to communicate. 3. Press and hold the Talk button while speaking into the microphone. 4. When finished talking, release the Talk button and listen for a response. Communicating with Another Person Turning on Your Radio Turn On/Off VOL Knob (Fig.
ENGLISH Lock Function The Lock function locks the Up, Down, CH/CODE/ Roger Beep, VOX and Vibra Alert buttons to prevent accidental operation. Fig. 16 To turn the lock on or off: – Press and hold the Call/Lock button for two seconds. (Fig. 16) A double beep sound is used to confirm your lock on or off request. When in Lock mode, a 3 beeps warning shows that the related buttons would not be operated. Range Fig. 17 Your range will vary depending on terrain and conditions.
ENGLISH To Select a Channel Privacy Codes The radio has 22 Channels that preset with customized privacy codes, see Channel and Default Privacy Code Table on page 9. 1. During Standby mode, press and release the CH/CODE button (Fig. 21), the current channel number and user adjusted privacy code setting (if any) prompted. 2. After the current channel number prompted, press the Up or Down button to select a channel (Fig. 22). Or press and hold the Up or Down button for fast skipping. Fig. 21 Fig. 22 3.
ENGLISH Set CTCSS Privacy Codes To select a CTCSS privacy code: 1. During Standby mode, press and release the CH/CODE button to select a desired channel (Fig. 23). Reset all channels with factory default privacy codes Fig. 23 2. Within 5 seconds, press and hold the CH/CODE button until the current code number prompted and the Red and Green LED flash alternatively. The following messages may be prompted: a.
ENGLISH Voice Activated Transmit (VOX) Key Tone In VOX mode, your radio can be used “hands-free,” automatically transmitting when you speak. You can set the VOX sensitivity level to fit the volume of your voice and avoid transmissions triggered by background noise. Key Tone is an audible tone which will sound each time a button is pressed. To turn VOX mode on: 1. During Standby mode, press and hold the VOX button until the current VOX status and the current VOX Sensitivity Level are prompted (Fig. 29).
ENGLISH Warranty & Trademark Acknowledgment Limited Lifetime Warranty on Radio DEWALT warrants to the original consumer purchaser only that this product and the component parts thereof, will be free from defects in workmanship and materials. DEWALT will, repair or replace, at its sole option and discretion, this product or any defective parts.