DISTRIBUTION AMPLIFIERS MANUAL PART NUMBER: 400-0018-003 PRODUCT REVISION: 0 DA1406WM 1-IN, 6-OUT MAC DISTRIBUTION AMPLIFIER USER’S GUIDE
DISTRIBUTION AMPLIFIERS INTRODUCTION TABLE OF CONTENTS Page Thank you for purchasing the DA1406WM Distribution Amplifier. We are sure you will find it a reliable and useful product. PRECAUTIONS / SAFETY WARNINGS ...............2 GENERAL ................................ .......................... 2 Superior performance for the right price backed by solid technical and customer support is what we have to offer. INSTALLATION................................ ..................2 CLEANING.....................
DISTRIBUTION AMPLIFIERS PRECAUTIONS / SAFETY WARNINGS • 1 Please read this manual carefully before using your DA1406WM Distribution Amplifier. Keep this manual handy for future reference. These safety instructions are to ensure the long life of your DA1406WM and to prevent fire and shock hazard. Please read them carefully and heed all warnings. • 1.1 GENERAL • Unauthorized personnel shall not open the unit since there are high-voltage components inside.
DISTRIBUTION AMPLIFIERS • Any changes or modifications to the unit not expressly approved by Altinex, Inc. could void the user’s authority to operate the equipment. ABOUT YOUR DISTRIBUTION AMPLIFIER MECHANICAL DA1406WM Material 0.1” Al Finish Gray Top Panel Lexan Height (inches) 1.75in (44mm) Width (inches) 8.50in (216mm) Depth (inches) 4.50in (114mm) Weight (pounds) 2.0lbs (0.91kg) Ship Weight (pounds) 3.2lbs (1.
DISTRIBUTION AMPLIFIERS DESCRIPTION OF DA1406WM 4 PIN No. 4.1 INPUT AND OUTPUTS Using female 15-pin D (MAC-type) connectors on all input and output connectors, the DA1406WM can be used with readily available MAC-type cables. If desired, the input and/or outputs of the DA1406WM can be easily adapted to 5-BNC connectors to allow it to be used with RGsB, RGBS, or RGBHV signal types as well. This requires the use of Altinex MS8100 series adapter cables (15 pin to 5 BNC).
DISTRIBUTION AMPLIFIERS PIN No. Input signals on 15-pin D female connector 12 Vertical Sync 13 Ground 14 Ground 15 Horizontal Sync Table 4. The DA1406WM Input pin-out 4.2 BOOT UP SWITCHES Some Video cards require the proper sense ID pins to determine the boot up mode. Sense pins are usually present on MAC video cards. When distribution amplifiers are used, the local monitor (monitor connecting directly to the computer) is no longer available.
DISTRIBUTION AMPLIFIERS INSTALLING YOUR DISTRIBUTION AMPLIFIER OPERATION 6 Step 1. Make sure that the power input is set to the proper AC voltage in your country. An incorrect setting can result in equipment damage not covered by warranty. If the power input voltage needs to be changed, remove the fuse portion of the power entry module and change the location of the fuse. Note that the correct voltage is visible through the voltage designation window. Step 2.
DISTRIBUTION AMPLIFIERS ACCESSORIES Model No.
DISTRIBUTION AMPLIFIERS TROUBLESHOOTING GUIDE 11.2 RETURN POLICY It is very important that you receive products that you have ordered and that this product fulfills your need. In the unlikely event that an Altinex product needs to be returned please follow the policies below: 10 We have carefully tested and have found no problems in the supplied DA1406WM unit; however, we would like to offer the following suggestions: • Check to insure the power input is set to proper AC voltage.