User's Manual

eWheels V2 user manual

1. Power on: EWheels will display the current battery level and automatically enter the braking

state.

2. Press the SPEED_UP button on the remote control and the eWheels begins to move. As you

advance, press the buttons SPEED_UP and

SPEED_DOWN on the remote control to speed up or slow down. Whenever the STOP button on

the remote control is pressed, eWheels

STOP.

3. Pressing the STOP button on the remote control for more than three seconds causes eWheels

to unbrake and be in a free state.

FCC STATEMENT :

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:This device may not cause harmful interference, and

FCC STATEMENT :

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause

undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

eceiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance 20cm

between the radiator & your body.

PAGE 1
eWheels V2 user manual 1. Power on: EWheels will display the current battery level and automatically enter the braking state. 2. Press the SPEED_UP button on the remote control and the eWheels begins to move. As you advance, press the buttons SPEED_UP and SPEED_DOWN on the remote control to speed up or slow down. Whenever the STOP button on the remote control is pressed, eWheels STOP. 3.
PAGE 2
- English: " This device complies with Industry Canada licence-exempt RSS standard( s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device." - French:" Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.