Data Sheet

Product Specification Sheet APS516 - Rev. 07/2013
CSM-4 4-Camera Switching Module
42 Central Drive • Farmingdale • NY • 11735-1202 • Phone: [phone] • Fax: [phone]
TOLL-FREE: [phone] • Web: AlphaCommunications.com • Email: [e-mail]
Copyright© 1998-2014 Alpha Communications® - All Rights Reserved.
Due to continuous product improvement, all colors, sizes, materials, finishes and specifications are subject to change without notice.
< Previous (APS515) Next (APS517) >
Architects' And Engineers' Specifications
The 4-camera switching module(s) shall be Alpha
Communications® / S.T.R.™ CSM-4. Switching module(s) shall be
installed in place of the blank module(s) found between the
monitors and the handsets. Switching module(s) shall feature four
(4) front mounted momentary push buttons marked CAM1,
CAM2, CAM3 and CAM4. Switching module(s) shall be finished in
the same white plastic finish as the monitor handsets and
button markings shall be silk-screened.
Contractor shall furnish and install the necessary TU1007A
and DPS-2 switching components, as required, and any
compatible CCTV cameras needed.
Contractor shall observe all local and national electrical and
building codes.
CSM-4 4-Camera Switching Module
The Alpha Communications® / S.T.R.™ CSM-4 4 Camera Switching
Modules are designed to be used with the VH30 series video-
intercom monitor stations. The CSM-4 installs in place of the
blank panel found between the monitor and the handset, allowing
the resident to switch between up to four (4) CCTV cameras at
various building locations.
The four (4) camera switching buttons are marked CAM1, CAM2,
CAM3 and CAM4 and match the styling found on the monitor
handsets. The CSM-4 is easily installed in place of the blank
module and can be added to the monitor(s) at a later time
if required.
Features
Four (4) Momentary Buttons marked CAM1, CAM2, CAM3 and
CAM4
Easily installs in place of blank module
Matches styling of handset buttons
Rugged and Reliable. Simple to Operate
Specifications
Dimensions:
1.10"W (28mm) x 8.50"H (216mm) x 0.75"D
(20mm).
Finish:
Same White Plastic as found on the HT3003/2W
monitor handset
Markings: Silk-Screened
NO T E S: For switching to 1-2 cameras you must add 1-
TU1007A and 1- DPS-2 switching units to the main system
power supply. For switching to 3-4 cameras you must add 2-
TU1007A and 2- DPS-2 switching units to the main system
power supply. The blank buttons shown on the top are used
for other purposes and do not function on the CSM-4 units.