Data Sheet

Product Specification Sheet APS120 - Rev. 07/2013
BF Series Station Connecting Cords
42 Central Drive • Farmingdale • NY • 11735-1202 • Phone: [phone] • Fax: [phone]
TOLL-FREE: [phone] • Web: AlphaCommunications.com • Email: [e-mail]
Copyright© 1998-2014 Alpha Communications® - All Rights Reserved.
Due to continuous product improvement, all colors, sizes, materials, finishes and specifications are subject to change without notice.
< Previous (APS119) Next (APS121) >
BF Series Station Connecting Cords
Typical STRAIGHT Cord
Typical COILED Cord
BF Series Station Connecting Cords
The Alpha Communications® 'BF' series station connecting cords
are used with many 'AA' (master) and 'AB' (remote) series intercom
stations.
These cords are designed to plug into the intercom station(s) and
then plug into the flush or surface wall jack(s), where they are
hard-wired to the system wiring.
The various models are available in different lengths and in
'straight' or 'coiled' configurations, to meet your individual
requirements. All models have plug-in connectors on both ends.
Models / Types
BF640*: 6' Straight Cord--8 Pin--Beige
BF640A*: 6' Straight Cord--8 Pin--Black
BF641*: 20' Straight Cord--8 Pin-- Beige
BF641A*: 20' Straight Cord--8 Pin--Black
BF642*: 7' Coiled Cord--8 Pin--Beige
BF642A*: 7' Coiled Cord--8 Pin--Black
BF643*: 1' Coiled Cord--8 Pin--Beige
BF643A*: 1' Coiled Cord--8 Pin--Black
BF923**: 6' Straight Cord--4 Pin-- Black
BF923A**: 20' Straight Cord--4 Pin--Black
BF926**: 7' Coiled Cord--4 Pin-- Black
BF940**: 6' Straight Cord--6 Pin-- Black
BF940A**: 20' Straight Cord--6 Pin--Black
BF941**: 7' Coiled Cord--6 Pin-- Black
* Requires KB170 (flush) or KB171 (surface) wall jack
** Requires KB157P (flush) wall jack
Architects' And Engineers' Specifications
The intercom station connecting cord(s) shall be Alpha
Communications® 'BF' series or approved equal. Cord(s) shall be
selected depending upon model of intercom master and/or
remote station(s) and length/type desired for that location.
Cord(s) shall have plug-in connectors on both ends and shall
connect to the appropriate wall mount plate/jack.
Contractor shall observe all local and national electrical and
building codes.