Data Sheet

Product Specification Sheet APS915 - Rev. 08/2014
4800V Remote Call Station with Intercom (St. Steel)
42 Central Drive • Farmingdale • NY • 11735-1202 • Phone: [phone] • Fax: [phone]
TOLL-FREE: [phone] • Web: AlphaCommunications.com • Email: [e-mail]
Copyright© 1998-2014 Alpha Communications® - All Rights Reserved.
Due to continuous product improvement, all colors, sizes, materials, finishes and specifications are subject to change without notice.
< Previous (APS914) Next (APS916) >
4800V (Flush Mount)
Architects' And Engineers' Specifications
Remote Call Station(s) shall be Alpha Communications® / Cornell
4800V (flush mount) or approved equal. Station(s) shall provide a
call-placed indicator, a large momentary 1.5" Red Mushroom Head
call pushbutton and call received/audio-on LED indicator.
All components of the station shall be mounted on a durable satin
finish Stainless Steel faceplate. The 4800V shall flush mount over
a 4" Masonry Box (Raco model# 696 or equal). When used with the
4800 series system, contractor shall furnish and install a model
RSN7049 self-stick instructional sign, adjacent to each 4800V
remote call station.
The 4800V shall be wired using standard Cat5e cabling (with RJ45
connector) and shall contain a built-in Form 'C' relay for remote
signaling when a call is placed.
Contractor shall observe all local and national building and
electrical (and A.D.A.) codes.
4800V Remote Call Station with Intercom (St. Steel)
The 4800V Digital Area of Rescue/Refuge Assistance Call Station
will initiate a call at the Control Panel(s) when button is pressed.
When not answered on site after a pre-programmed time has
elapsed, the Main Panel will call off site to an emergency phone
number of your choice.
The 4800 series system can support a total of 255 Call Stations.
The The 4800V Station will initiate an alarm at the Control
Panel(s) when the button is pressed.
As an option, The 4800V Call Station provides an auxiliary set of
momentary Form 'C' contacts that can be used to activate
external devices, such as a camera, strobe, or tone device. Please
refer to the installation manual for more information on this option.
Each 4800V Call Station should be mounted in a 4" Masonry Box,
Raco model# 696 or equivalent, in a controlled indoor environment.
The Call Stations connect to a Control Panel or Expansion Switch
using an RJ45 connector and Cat5e cable.
Features
Large momentary 1.5" diameter Red Mushroom Head
Pushbutton
Call-received and Audio-on LED indicator
Auxiliary Form 'C' contacts
Convenient Cat5e cabling
Sensitive speaker/microphone
Attractive and durable satin finish Stainless Steel faceplate
Specifications
Dimensions: Height: 4.50" (115mm); Width: 4.50" (115mm)
Power Req. 24VDC (from system power supply)
Construction: Durable satin finish Stainless Steel faceplate
Button:
Large momentary 1.5" diameter Red Mushroom
Head Pushbutton
Operating
Temp:
50-120°F Indoor Non-condensing
Housings: 4" Masonry Box (Raco #696 or equivalent)
Wiring:
Cat5e cable, standard straight-thru, TIA/EIA
568A or TIA/EIA 568B.2