AP200 Wireless Access Point Quick Installation Guide
AP200 Wireless Access Point Quick Installation Guide Introduction This guide is to assist the reader with the most basic form of installation and connection to this access point. Package Contents After purchasing the access point, the following items will be included in the package: • • • • • One AP200 Wireless Access Point. One Quick Installation Guide. One power supply adapter. One rack/wall-mount back plate. Two Phillips-head screws with anchor plugs. 3.
Quick Installation Guide AP200 Wireless Access Point The LED indicator on the front panel of the access point should come on. 3. Position the access point over the mounting back plate and align the slider pegs into the slider peg holes. Carefully slide the access point downwards until the access point stops into position. Connect the Ethernet Cable The following steps explain how to successfully connect the non-PoE Ethernet cable to the access point. 1. 2.
AP200 Wireless Access Point Quick Installation Guide Safety Precautions For your protection, observe the following safety precautions when setting up your equipment: • • The LED indicator on the front panel of the access point should come on. • Software Connection The default IP address of the access point is 192.168.0.50 with a subnet mask of 255.255.255.0. • By default, the username is admin and there is no password.
Quick Installation Guide • AP200 Wireless Access Point Circuit Overloading: Consideration should be given to the connection of the equipment to the supply circuit and the effect that overloading of circuits might have on overcurrent protection and supply wiring. Appropriate consideration of equipment nameplate ratings should be used when addressing this concern. • • This device complies with Part 15 of the FCC Rules.
AP200 Wireless Access Point 4. Quick Installation Guide A copy of the GPL is included herewith, may be obtained at http://www.gnu.org, and may also be found at http://www.canarynetworks.com/support. Modification of or tampering with the software of this device, including but not limited to any Open Source Software, is solely at your own risk. Canary Networks is not responsible for any such modification or tampering.
