Product User Manual For 802.11b/g MIMO Mini-PCI Card (Ralink Solution) Model Number: WMP-N07 Revision: 1.
Revision History Rev. Date Author Reason for Changes 1.
Contents 1.0 SCOPE.............................................................................................................................................5 1.1 DOCUMENT ....................................................................................................................................5 1.2 PRODUCT FEATURES .......................................................................................................................5 2.0 REQUIREMENTS..............................................
1.0 Scope 1.1 Document This document is to specify the product requirements for 802.11b/g MIMOMini-PCI Card. This Mini-PCI Card is based on Ralink RT2800 chipset that complied with 802.11n draft 1.0 standard from 2.4~2.5GHz, and it can be used to provide up to 11Mbps for IEEE 802.11b and 54Mbps for 2.4GHz IEEE 802.11g to connect your wireless LAN. With seamless roaming, fully interoperability and advanced security with WEP standard, 802.
2.2 General Requirements 2.2.1 IEEE 802.11b Section # Feature Detailed Description 2.2.1.1 2.2.1.2 Standard Radio and Modulation Schemes Operating Frequency Channel Numbers y y IEEE 802.11b DQPSK, DBPSK, DSSS, and CCK y 2400 ~ 2497MHz ISM band y Data Rate Media Access Protocol Transmitter Output Power Receiver Sensitivity y y 11 channels for United States 13 channels for Europe Countries 14 channels for Japan 11, 5.5, 2, and 1Mbps CSMA/CA with ACK y Typical 18dBm (+-2dB) at 11, 5.
2.2.3 High Throughput Section (HT Mode) # Feature Detailed Description 2.2.2.1 2.2.2.2 Standard Radio and Modulation Type Operating Frequency Channel Numbers y y IEEE 802.11n draft 1.0 BPSK, QPSK, 16QAM, 64QAM with OFDM y y Data Rate Media Access Protocol Transmitter Output Power y y 2400 ~ 2483.5MHz ISM band 11 channels for United States 13 channels for Europe Countries 13 channels for Japan From MCS – 0 to MCS –15 as shown in Appendix A CSMA/CA with ACK 2.2.2.3 2.2.2.4 2.2.2.5 2.2.2.6 2.2.2.
2.3 Software Requirements The Configuration Software supports Microsoft Windows 98SE, ME, 2000, and XP. This configuration software includes the following functions: y Information Information allows you to monitor network status. y Configuration Configuration allows you to configure parameters for wireless networking. y Security Supports enhanced security WEP, 802.1x,WPA. 2.3.1 Information # Feature Detailed Description 2.3.1.1 General Information y 2.3.1.2 Current Link Information y 2.3.1.
# Feature Detailed Description 2.3.3.2 WEP Management y y 2.3.3.3 2.3.3.4 802.1x WPA y y y y Four WEP keys can be selected STA with WEP off will never associate any AP with WEP enabled WEP Key Format: Option for Hex format Support EAP-TLS, EAP-TTLS, and EAP-PEAP Support WPA-PSK and WPA-EAP Support Cipher Mode AES and TKIP 2.4 Mechanical Requirements # Feature Detailed Description 2.4.1 2.4.2 2.4.3 Length Width Height y y y 50.8mm 59.59mm 0.99mm 2.
FCC statement in User's Manual (for class B) "Federal Communications Commission (FCC) Statement This Equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
FCC Statements: 1. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. 3.