User's Manual

Door / Window Sensor
ADZ01
User Manual
Key Features:
Z-Wave 800 series design, support
Z-wave LR and compatible with
Z-Wave Mesh.
Includes tamper protection of both
front lid as well as base of the Main
Unit.
1 mile under LR mode, up to 200 feet
under Z-wave mesh mode.
Wear resistant surface, suitable for
most of the environments
Low Battery Indication, AAA battery
Easier to buy and replace
Good to place on door, window,
furniture. intended for residential as
well as commercial applications.
Optimally placing Door /
Window Sensor
Door / Window Sensor has been
designed to be mounted on the edge of a
door or moving window. To optimally
install it, please note the following;
Door / Window Sensor must be
installed so that its two parts
(Magnet and Sensor) separate when
the door or window is opened and
come together when closed.
As a magnetic sensor utilising
wireless communication, Door /
Window Sensor may not optimally
work when mounted on a metal
frame.
Note that both pieces of the sensor
feature of a line notch of the sensor
body and magnet. When installed,
the two marks should align in order
to optimise sensor performance with
a gap of no more than 15mm between
them.
Test Door / Window Sensor in your
selected installation location prior to
permanently installing it with the
provided tape or screws.
Power Door / Window Sensor
To power on your Door / Window Sensor
with the included AAA battery, follow
these steps:
Press the bottom cover of your Door /
Window Sensor, then remove the
case in the direction of arrow.
Remove the plastic tab blocking
connection of the battery. The LED
will blink green once and then
colorful gradient alternately when
not connected to a Z-Wave
Controller upon initial power.
Adding(Inclusion)
Follow the instructions for your Z-Wave
Certified Controller adding inclusion
mode.. When prompted by the
controller:
1. The Door Sensor should be within 10’
of your Z-Wave controller for the
inclusion process. After successful
pairing, the device can be brought to
the desired location.
2. Set the main controller into
(security/non-security) adding mode
(see the controller’s manual).
3. Press and hold Action Button for 3
seconds for device inclusion.
The indicator LED will flash green five
times indicating inclusion
successful,then it fails to be included,
you need to repeat the above
process.
4. If your Z-Wave gateway support
SmartStart: scan the QR code on
Door / Window Sensor using the
gateway’s app. Your sensor will join
your Z-Wave network automatically.
Removing(Exclusion)
Follow the instructions for your Z-Wave
Certified Control enter exclusion mode.
When prompted by the controller:
1. Remove the Main Body Cover from
the Bottom Cover.
2. Press the Action Button quickly 3
times in a row. The LED will be
colorful gradient for 5 seconds and
then off indicating exclusion
successful.
Resetting the Door / Window
Sensor
If needed, the Door / Window Sensor can
be reset locally by following these steps.
Only do this when your Z-Wave controller
is disconnected or otherwise
unreachable. Beware that resetting your
device will disconnect it from the
system:
1. Remove the Main Body Cover and
confirm that your Door / Window
Sensor is powered on.
2. Press and hold Action Button for 12
seconds then release. A flashing light
with two colors alternately indicates a
successful factory reset.
3. The Door / Window Sensor’s memory
will be erased to factory settings.
Waking Up the Door /
Window Sensor
Door/Window Sensor is a battery
powered device, it wakes up on regular
intervals to give battery and other status
Physical Characteristics
Bottom
Cover
Tamper
Switch
Action
Button
Figure 1
Figure 2
Magnet
Notch
LED