Installation Instructions

Handheld Wireless Remote TX-SL016

OPERATION

：

1. Operation:

Press on/off power button to Switch on or off searchlight.

Operate directions of the light beam by pressing the direction

buttons.

Up = Down = Right = Left =

2. Power Switch: Turn on to rotate or tilt the searchlight.

3. Speed Switch: Switch between fast and slow movement speed.

4. Lamp Switch: Turn on or off LED of the searchlight.

5. Flicker Switch: Turn on or off flashing function of LED.

REMOTE PROGRAMMING PROCESS

：

1. Switch off DC Power or disconnect from battery.

2. Make sure there is NO other transmitter operating at the same time.

3. Switch on DC Power, within 5 seconds press Remote up ▲ and down ▼button

once simultaneously.

4. Searchlight will flash to acknowledge the Remote, connection has been

made.

5. To program the second Remote (up to 4 remotes may be used with the

searchlight, programming a fifth will replace the first), within five seconds after

the first Remote programmed, press the second Remote up and down button or

repeat step 1.

RADIO FREQUENCY

：

2406MHz

Wireless Remote Battery: 23A*2pcs

Wireless Remote Operation Distance: 65M

PAGE 1
REMOTE PROGRAMMING PROCESS： Handheld Wireless Remote TX-SL016 1. Switch off DC Power or disconnect from battery. 2. Make sure there is NO other transmitter operating at the same time. 3. Switch on DC Power, within 5 seconds press Remote up ▲ and down ▼button once simultaneously. 4. Searchlight will flash to acknowledge the Remote, connection has been made. 5.
PAGE 2
FCC INFORMATION The Federal Communication Commission Radio Frequency Intererence Statement includes the following paragraph: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.