Installation Instructions

Handheld/Dashmount Wireless Remote TX-SL015

OPERATION

：

1. Operation

Press on/off button to Switch on or off searchlight.

Operate directions of the light beam by pressing the direction

buttons.

Up = Down = Right = Left =

2. Power Switch

3. Speed Switch

4. Lamp Switch

5. Flicker Switch

REMOTE PROGRAMMING PROCESS

：

1. Switch off DC Power or disconnect from battery.

2. Make sure there is NO other transmitter operating at the same time.

3. Switch on DC Power, within 5 seconds press Remote up ▲ and down ▼button

once simultaneously.

4. Searchlight will flash to acknowledge the Remote, connection has been

made.

5. To program the second Remote (up to 4 remotes may be used with the

searchlight, programming a fifth will replace the first), within five seconds after

the first Remote programmed, press the second Remote up and down button or

repeat step 1.

RADIO FREQUENCY

：

433.92MHz

Wireless Remote Battery: 23A*2pcs

Wireless Remote Operation Distance: 65M

PAGE 1
Handheld/Dashmount Wireless Remote TX-SL015 REMOTE PROGRAMMING PROCESS： 1. Switch off DC Power or disconnect from battery. 2. Make sure there is NO other transmitter operating at the same time. 3. Switch on DC Power, within 5 seconds press Remote up ▲ and down ▼button once simultaneously. 4. Searchlight will flash to acknowledge the Remote, connection has been made. 5.
PAGE 2
FCC INFORMATION The Federal Communication Commission Radio Frequency Intererence Statement includes the following paragraph: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.