Installation Instructions

TX-SL009D Wireless remote control for Dashboard

Instruction

OVERVIEW:

REMOTE PROGRAMMING PROCESS

：

1. Switch off DC Power or disconnect from battery.

2. Make sure there is NO other transmitter operating at the same time.

3. Switch on DC Power, within 5 seconds press Remote up ▲ and down ▼button

once simultaneously.

4. Searchlight will flash to acknowledge the Remote, connection has been made.

5. To program the second Remote (up to 4 remotes may be used with the searchlight,

programming a fifth will replace the first), within five seconds after the first

Remote programmed, press the second Remote up and down button or repeat

step 1.

INSTALLATION:

1. OPEN UP

PAGE 1
TX-SL009D Wireless remote control for Dashboard Instruction OVERVIEW: REMOTE PROGRAMMING PROCESS： 1. Switch off DC Power or disconnect from battery. 2. Make sure there is NO other transmitter operating at the same time. 3. Switch on DC Power, within 5 seconds press Remote up ▲ and down ▼button once simultaneously. 4. Searchlight will flash to acknowledge the Remote, connection has been made. 5.
PAGE 2
. SCREW the TX-SL009D on the Dashboard Length Unit: mm
PAGE 3
FCC INFORMATION The Federal Communication Commission Radio Frequency Intererence Statement includes the following paragraph: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.