User's Manual

BURY GMBH & CO. KG

ROBERT-KOCH-STRASSE 1-7

D-32584 LÖHNE

page 1 / 6

M900_01_Alligator_Vehice_Router

1. Setting up DUT.

DUT [1]

shall be connected as this on Pic

Red connector to supply (

Molex 8pin connector to RS485

[4] Status diode

will show the used

After connection of power

Picture

1: DUT with ancillary devices

Manual

for

M900_01_Alligator_Vehice_Router

shall be connected as this on Pic

ture 1.

Red connector to supply (

12V/24V) and black to GND [2],

Molex 8pin connector to RS485

-USB converter [3].

will show the used

test mode optical.

After connection of power

supply, DUT will be switch on automatically.

1: DUT with ancillary devices

PAGE 1
BURY GMBH & CO. KG ROBERT-KOCH-STRASSE 1-7 D-32584 LÖHNE Manual for M900_01_Alligator_Vehice_Router 1. Setting up DUT. DUT [1] shall be connected as this on Picture Pic 1. Red connector to supply (12V/24V) ( and black to GND [2], Molex 8pin connector to RS485-USB RS485 converter [3]. [4] Status diode will show the used test mode optical. After connection of power supply, DUT will be switch on automatically.
PAGE 2
BURY GMBH & CO. KG ROBERT-KOCH-STRASSE 1-7 D-32584 LÖHNE Please connect [2] connection to Power supply. 2. To set Rx or Tx mode: - On first step you have to install drivers for RS485 to USB converter. Driver setup exe you will find on the included CD (“RS485 drivers.exe”). - RS485-USB converter must be connected to PC, and will be controlling by Docklight software (installation for evaluation version You can find on the CD). - After start Docklight software chose ok on the registration widow.