welcoming • sophisticated • inspiring 800192 APPROVED FOR USE IN WET LOCATIONS allen + roth® is a registered trademark of LF, LLC. All Rights Reserved. ITEM #2602000 WALL LANTERN MODEL #WL135MBK Français p.10 Español p. 19 ATTACH YOUR RECEIPT HERE Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-866-439-9800, 8 a.m. - 8 p.m., EST, Monday - Sunday.
TABLE OF CONTENTS Package Contents ............................................................................................................... 2 Hardware Contents .......................................................................................................................... 3 Safety Information ............................................................................................................... 3 Preparation ...........................................................................
HARDWARE CONTENTS (shown actual size) AA BB Wire Connector Machine Screw Qty. 3 Qty. 2 SAFETY INFORMATION READ AND SAVE THESE INSTRUCTIONS. DANGER • For your protection and safety, carefully read and understand the information provided in this manual completely before attempting to assemble, install or operate this product. Failure to do so could lead to electrical shock, fire or other injuries that could be hazardous or even fatal.
SAFETY INFORMATION WARNING • All electrical connections must be in agreement with local codes and ordinances, the National Electric Code (NEC) and ANSI/NFPA 70-1999. Contact your municipal building department to learn about your local codes, permits and/or inspections. Risk of fire - most dwellings built before 1985 have supply wire rated for 140°F. Consult a qualified electrician before installation.
ASSEMBLY INSTRUCTIONS 1. Turn off circuit breakers and wall switch to the fixture supply line leads. 1 DANGER: Failure to disconnect power supply prior to installation may result in serious injury or death. 2. Remove existing fixture and disconnect all electrical wiring. ON ON OFF OFF 2 Outlet Box 3 3. Remove two decorative nuts (C) and washers (E) from front of fixture (A) and remove mounting plate (B) from back of fixture (A).
ASSEMBLY INSTRUCTIONS 4. Attach mounting plate (B) to outlet box (not included) using the existing washers and outlet box screws or the machine screws (BB). Note: If the outlet box screws required for your outlet box are of a different size than the machine screws (BB), consult with a licensed electrician before proceeding. 4 BB Use level (not included) to make sure preassembled screws (D) are level vertically. This will help ensure the fixture (A) is level when attached.
ASSEMBLY INSTRUCTIONS 5. Unwrap BARE wire from BLACK and WHITE wires. Prepare wire by stripping 3/4 in. of insulation from wire ends using wire strippers (not included). Connect WHITE wire from fixture (A) to WHITE wire from outlet box using existing wire connector or wire connector (AA). Connect BLACK wire from fixture (A) to BLACK wire from outlet box using existing wire connector or wire connector (AA).
ASSEMBLY INSTRUCTIONS 7. Align holes in fixture (A) with screws (D) on mounting plate (B) and push fixture (A) toward wall. Attach fixture (A) to mounting plate (B) using the washers (E) and decorative nuts (C) previously removed (Step 3, page 5). 7 D E A C C 8. Install one standard-base 8-watt max.LED bulb (not included) or incandescent/CFL equivalent. 8 WARNING: When replacing bulb, allow bulb and fixture to cool down before touching. A Restore power and test fixture (A).
CARE AND MAINTENANCE • Shut off main power supply. Wipe fixture with soft, damp cloth. Use window cleaner to clean glass. Do not use an abrasive cleaner on glass or fixture. TROUBLESHOOTING WARNING: Before beginning work, shut off the power supply to avoid electrical shock. PROBLEM Bulb will not light. POSSIBLE CAUSE 1. Bulb is burned out. 2. Power is OFF. 3. Faulty connection. CORRECTIVE ACTION 1. Replace bulb. 2. Make sure power supply is ON. 3. Check wiring and all connections.