User Guide

4
1.3 MASTER SECTION
1. MAIN OUT L & R are line level outputs for the main stereo
mix using standard XLR output connectors and are
impedance balanced for rejection of unwanted interference.
2. AUX OUT is a line level output from the AUX buss and uses a
standard 1/4”(6.25mm) jack socket.
This can be used for connecting to external equipment such
as a monitor speaker or a phones/ in-ear monitoring system.
3. FX OUT/FOOTSWITCH is a line level output from the FX buss
and uses a standard 1/4”(6.25mm) jack socket.
This can be used for connecting to external equipment such
as another effects processor. The output of external effects
processors should be returned into ST1 or ST2 Inputs.
For ZEDi-10FX a latching footswitch can be connected to the
FX OUT instead and used to mute the output from the
ZED FX Multi Model processor.
The footswitch must be wired between Tip and Sleeve.
4. AUX MASTER controls the volume of signal from the AUX
OUT.
5. XLRs = MONS switches the PFL signal to the MAIN OUT
as well as the PHONES output for flexible monitoring of input
signals through your speakers.
This is mainly for studio control room monitoring applications.
6. 48V switches industry standard 48V (phantom power) to
all the microphone inputs for use with condenser microphones
and active D.I. boxes requiring +48V.
7. POWER LED indicates that the mixer is switched on.
8. MONITORS level controls the volume of signal from the
MONITOR OUT (shown section 3.)
9. MONITOR SOURCE select switches the source signal to
the MONITOR OUT between PHONES and MAIN MIX.
10. LR Meters display the level of the MAIN MIX or the mono
PFL signal if activated by any of the PFL switches.
11. PFL (Pre-Fade Listen) LED indicates when a PFL switch
has been pressed on one of the channels.
12. MAIN MIX fader is the master volume control for the main
stereo mix.
13. PHONES level controls the volume of signal to the
PHONES output.
14. PHONES SELECT switches the monitoring source from
FX SEND, AUX SEND or ST3 IN to the PHONES output.
When nothing is selected the default source is the MAIN MIX.
Pressing any PFL switch will override this to monitor the
selected channel input signal.
15. PHONES output uses a standard 1/4” (6.25mm) jack
socket.
Warning! To avoid damage to your hearing do not operate
headphones or sound system at excessively high volume.
Continued exposure to high volume sound can cause frequency
selective or wide range hearing loss! !