AI 020521

P1
020521-010-FR001 3-Light wall lamp
WARNING - TO REDUCE THE RISK OF FIRE OR INJURY:
1.lf you are unfamiliar with electrical wiring, call a qualified electrician to install this unit .More than
one person may be necessary to install fixture ,make sure you have enough qualified help.
2.Turn off the power to the fixture's circuit at the service panel. Use a voltage detector to verify that
the power is off.
3.DO NOT install bulb which exceeds the maximum wattage specified on the socket label.
Customer Service :[phone],[phone],[e-mail]
N
G
L
Step 1. Fix fixture crossbar 2 to outlet box 1
with original outlet box screws. Mark top and
bottom cross bar slots in the wall, remove
crossbar then install anchor screws in the
wall.
1-Outlet box with 2 screws (not supplied)
2-Cross bar with studs
3-Top slotted half disc
4-Top Disc w/holes
5-Decorative nuts
7-Threaded Rod
8-Bottom slotted half disc
9-Connector
10-Crystal Bobeche
11-Crystal ball ( I )
Step 2. Screw Crossbar 2 to outlet box 1 with
original outlet box screws. Make sure
crossbar studs are pointing away from wall.
Reinforce cross bar with top and bottom
anchor screws.
Step 3. Get fixture frame a few inches
close to wall and connect wires: Connect
fixture ribbed wire (L) to power supply
black wire. Connect fixture smooth wire
(N) to power supply white wire. Connect
fixture silver or copper bare wire (G) to
power supply green wire.
Step 4. Align fixture back plate holes to
crossbar studs 2 and fix it flat to wall,
secure fixture with decorative nuts 5, then
Install light bulbs.
Step 5. Install threaded rod 7 to bottom
of fixture, then install parts 8, 9, 10, and
11.
Proceed to install crystal set; follow
directions on pages 2 and 3 .
Anchor screws
Light bulb candelabra 40w max.
6-Middle slotted band