User's Manual

ManualsBrandsAliveal Enterprises ManualsCamera & Photo2.4GHz Wireless Video/Mic. Mini Camera

ALM-2471 2.4 GHz Wireless Video/Mic. Mini. Camera TX + Receiver

Include: 1pc Video/Mic. camera TX, 1pc Receiver, 2pcs Adapter, 1pc A/V Cable, 1pc 9V battery snap, and accessory pack

The ALM -2471 include a wireless video/Mic. super mini camera transmitter and a receiver unit. The mini camera

transmitter features super miniature size, video/Mic. performance, omni-directional antenna, and operates on 5 – 12vdc.

The receiver features built-in directional antenna and outstanding A/V reception quality. This system permits the wireless

transmission of Video/Mic. signal over a mini. distance of 300 meters in line-of-sight.

NOTE: Best results are achieved where there is clear “line of sight” between the camera transmitter and the receiver. Try to

avoid obstacles such as trees, walls, cars, trucks and buildings. Transmitting over water and in the rain will reduce performance.

Interference from certain electronic equipment or the moving human body can also effect the range obtainable.

For best reception, position the antennas of the transmitter and receiver 4.5 to 6 feet (1.5 to 2m) above the ground. Please test

all devices before final installation because the transmission quality can often be improved by moving the components slightly.

Turn off the camera transmitter and receiver if the system is not in use.

Do not touch the antennas when the system is switched on.

Do not place the receiver behind a monitor.

INSTALLATION:

1) The Mini camera TX features omni-directional antenna which is most effective when used in the UPRIGHT position.

2) Connect both the mini. camera transmitter and the receiver to their respective power supplies.

3) Connect the receiver to the equipment you wish to transmit to [monitor, TV, VCR, …etc.]

4) After connecting both the mini camera TX and the RX to their respective power supplies, obtain the best picture by adjusting

the position of the mini camera TX and the receiver unit to suit. Try slightly different locations of either unit for optimum results.

* (Direct the antenna of the receiver towards the antenna of the transmitter. The integrated antenna inside the case of the receiver

is located at the opposite end of the connectors.

FEATURES:

Mini Video/Mic. Camera Transmitter:

1) Miniature size for a wide range of applications.

2) Low power operating DC5 - 12V

3) Low power consumption of 80mA

4) Very steady and truly video/Mic. performance.

5) Outstanding transmitting range of 100M in L-O-S.

6) FCC and EC-R&TTE approved.

) ) ) ) ) )

CCTV Monitor

VCR or DVR

TELEVISION

Computer

(Converter

card is requested)

Summary of content (4 pages)

PAGE 1
ALM-2471 2.4 GHz Wireless Video/Mic. Mini. Camera TX + Receiver Include: 1pc Video/Mic. camera TX, 1pc Receiver, 2pcs Adapter, 1pc A/V Cable, 1pc 9V battery snap, and accessory pack The ALM -2471 include a wireless video/Mic. super mini camera transmitter and a receiver unit. The mini camera transmitter features super miniature size, video/Mic. performance, omni-directional antenna, and operates on 5 – 12vdc. The receiver features built-in directional antenna and outstanding A/V reception quality.
PAGE 2
IMPORTANT: 1) Avoid “Oily” locations. 2) Don’t place above or near a heat source which may cause the equipment to overheat. 3) Microwave ovens can cause interference and diminish the quality of the signal if the mini TX or receiver is located close by. 4) Beware of humid locations. Water droplets or spray may damage the units. If condensation does occur, do not use until the equipment has dried out. 5) Do not use in temperatures exceeding 55 degC.
PAGE 3
ALM-2472 2.4 GHz Wireless Super Mini. Camera Transmitter + Receiver Include: 1pc Video mini camera TX, 1pc Receiver, 2pcs Adapter, 1pc A/V Cable, 1pc 9V battery snap, and accessory pack The ALM -2472 include a wireless super mini camera transmitter and a receiver unit. The mini camera transmitter features super miniature size, omni-directional antenna, and operates on 5 – 12vdc. The receiver features built-in directional antenna and outstanding A/V reception quality.
PAGE 4
IMPORTANT: 1) Avoid “Oily” locations. 2) Don’t place above or near a heat source which may cause the equipment to overheat. 3) Microwave ovens can cause interference and diminish the quality of the signal if the mini TX or receiver is located close by. 4) Beware of humid locations. Water droplets or spray may damage the units. If condensation does occur, do not use until the equipment has dried out. 5) Do not use in temperatures exceeding 55 degC.