G29T SCREEN DISPLAY RECEIVER MEMORY Bold Welcome slide POWER & BATT.
23.500 SCREEN DISPLAY SCREEN DISPLAY 223.
223.500 seconds 5 seconds off seconds seconds seconds seconds seconds seconds off 223.500 223.
223.500 G29T “W e”.
POWER & BATT. “POWER & BATT” 223.500 30 minutes 223.
Batt. save off 0.2 : 0.2 0.2 : 1.8 0.2 : 1.2 0.2 : 0.4 0.2 : 0.8 (unit:seconds) 223.
SOUND “SOUND” 223.
223.500 band only band appears 223.
TRANSMITTER “TRANSMITTER” This function allows transmitting without using the PTT by simply speaking into the microphone. When you stop speaking, the unit will return to receive. At this state, the PTT key operation is suspended. 223.500 Choose a microphone to be used, or OFF to stop operating the VOX. 3.Press FUNC to start operating the VOX. RX Disabled will appear on the display. While operating, press down the dial twice. VOX level appears.
223.500 from “30 seconds” 78 223.
223.500 223.
PTT delay This is to cut the squelch tail noise that the repeater retransmits at the end of receiving tone-encoded CTCSS signals. Rotate the upper dial and select “PTT delay” “PTT delay” will be displayed as shown on the right. 223.500 PTT delay 0.6 Rotate the lower dial and select the desired PTT delay time. By rotating the dial, the PTT delay time changes as shown in the illustration. 0.3 0.6 1 (unit: seconds) 7 223.
REPEATER “REPEATER” . “REPEATER” “ON” “OFF” . 222MHz 902MHz 223.910 ~ 225.000MHz 927.000 ~ 927.995MHz Shift -1.
223.500 223.
223.500 50 50 100 200 223.500 1 ST” 1 ST” 20 20 40 2 seconds.
80 223.500 80ms. 20 2 seconds. 20 40 60 80 100 120 140 160 180 200 2s 80 223.500 80ms. 20 2 seconds.
RECEIVER 10-7-1 223.
to 223.500 10-7-3 DCS Operation Settings 223.